0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Does all motor oil drain from bottom plug on f-350 power-stroke diesel?
the oil that is in the oil filter will not drain from the oil pan plug but any oil in oil pan and engine will
Oil plug torque on 2004 sonata v6?
According to the service manual, you torque the oil pan drain plug to 25~33ft. lbs or 35~45nm
What is the torque spec on the oil drain plug on a 2002 Suzuki Esteem?
The Suzuki oil drain plug torque specification is 30 pounds. Over tightening the oil drain plug can cause the oil pan threads to strip.
Torque oil pan bolt?
Oil Pan bolts torque in sequence 15-22 lb ft. or if you mean the drain plug, that is 8-12 lb ft.
What is series 60 Detroit diesel oil pan bolt torque specification?
The oil pan bolt torque specifications, of a series 60 Detroit diesel engine, is 40 pounds. The bolts should be tighten by alternating end to end and side to side.
Torque on oil pan 1996 caravan 3.0?
Oil drain plug 30 ft lbs
Torque drain plug Mazda 3?
NEVER torque the oil plug!! just snug it up with 10 lbs of pressure. take it from experience, its happened to me, i had to replace the oil pan.
What is procedure for oil pan gasket replacement on a 97 Saturn?
drain the oil from the vehicle, unbolt the oil pan, scrape old gasket from pan and crankcase. check the torque specifications for the oil pan bolts (shouldnt be very high). replace the gasket and oil pan to factory torque specs. put drain plug back in and fill with factory specs of oil.
Oil pan bolts?
Oil Pan bolts torque in sequence 15-22 lb ft. or if you mean the drain plug, that is 8-12 lb ft.
What is the torque value of the drain plug on the oil pan of a 1998 Dodge Intrepid 2.7L?
30 foot pounds.
Where is the oil pan drain plug on a 2002 Blazer?
The oil pan drain plug is located on the oil pan.
What are the oil pan bolt torque specs on a C-12 caterpillar?
The oil pan bolt torque specifications, on your C 12 Caterpillar diesel engine, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
