The valve clearances are done hot not running are 0.35 for both inlet and exhaust to be done every 20,000 kms
easy job simply loosen top nut out to free valve and tighten up when desired clearance is achieved with good gauges!also for timing settings (do not attempt if you are not sure and dont have the right timingtools, settings are as follows -
"with number one piston at TDC injection pump plunger should read 0.65+-0.02mm.
special tools are need to service this area!
idle speed is 750 rpm (high hey!).
all info is correct on my mech spec sheet i acquired but no responsibility taken for updates .
What is the valve clearance setting for Qd32?
Stage 1 45nm,stage 2 65nm,stage 3 +90 degrees
What is the torque for the following Nissan navara QD32 1)main bearing cylinder head 3)conrod bearing 4)fly wheel
I need to know what the NM to do cylinder head fo QD32 and what is the sequence 9f doing properly, like where do I start?
Stage 1: 45Nm, Stage 2: 65Nm, Stage 3" +90 degrees. To convert to foot pounds multiply by 0.738
.55
6.8 Liters with oil filter replaced. you just need to patiently wait for a while for the oil to drop full inside the oil pan before measuring it again with its dipstick.