Yes the pulley has to be removed, To time this disconnect the spot plug(disables the computer) and set timing to factory spec's
what is the timing spec for a 94 camaro 3.4l v6i converted it to carb and points on distributor
no timing spec at all due to used timing chain.
10.
8 degrees
what are the timing spec for a 1965 ford galixie
The timing spec for that truck is 10-degrees BTDC (with the shorting bar removed from its connector, as shown in illustration 13.4).
6 degrees BTDC.
The valve clearances are done hot not running are 0.35 for both inlet and exhaust to be done every 20,000 kms easy job simply loosen top nut out to free valve and tighten up when desired clearance is achieved with good gauges!also for timing settings (do not attempt if you are not sure and dont have the right timingtools, settings are as follows - "with number one piston at TDC injection pump plunger should read 0.65+-0.02mm. special tools are need to service this area! idle speed is 750 rpm (high hey!). all info is correct on my mech spec sheet i acquired but no responsibility taken for updates .
.15-.18"
its a 350
I read elsewhere (i.e. not confirmed by me) that the Pathfinder water pump torque spec is 12-15 ft-lbs.