Yes the pulley has to be removed, To time this disconnect the spot plug(disables the computer) and set timing to factory spec's
fahk jeew
Power steering box... Steering fluid level low,dirty or needs replacing... If power steering fluid is white then your box is damaged...
To find the horn relay on a 1987 Ford Ranger, look along the steering column under the dash. Here you will find the speed control amplifier bracket, which is what the horn relay is connected to.
You drive the cold roll pin out, BUT if planning on replacing slave cyl, replacing the master line and slave as a unit is recommended more often then not there will be a leak when replacing line.
It needs replacing every 60,000 miles.
Seals are probably shot. Replace the pump/reservoir assembly.
Yes.
The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.
There is a serpentine belt listed for the 1996 Ford Ranger - 2.3 L - 4 cylinder engine without power steering / without air conditioning all the rest of the serpentine belts listed for the 2.3 L / 3.0 L / and 4.0 L engines have power steering with and without air conditioning
need locations of steering column brackets on a 1998 ford ranger
You can remove the steering will, on your Ford Ranger pickup truck, by removing the steering wheel pin. Remove the wiring harness and the steering wheel will come off.
where is the number 3 cylinder located on a 2.5 ford ranger engine