0
i know from 1984 to 1994 22r 22re and 22rtec all shared the same bell housing just that some had dowl pins different places
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Will a c6 fit a 360 ford engine?
Depends on the C6. The 360 is from the FE/FT big block ford family. If the C6 came from behind a 331-428 big block, it will fit the 360. The exception being the 335 series big block trannies (351 C or M, 400) or the 385 series big block trannies (429, 460). The 335 and 385 series big blocks shared a bell housing (with some rare exceptions in the 335 family which had a small block bell housing) which was rifferent from the FE/FT.
Is a 460 bell housing and a 6.9 diesel bell housing the same?
No it is not
Will a 350 engine fit a 454 mercruiser bell housing?
yes it will. chevy V8 engines all shared the same bell housing bolt pattern. you may need to replace the flywheel though as 454 were usually externally balanced where 350 was internally balanced.
Where is the bell housing on a Jeep?
The bell housing is the part of the transmission case that bolts to the engine. The bell housing contains the clutch or torque converter.
Where is crank shaft sensor located on a 1997 Jeep Grand Cherokee?
4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.
Where is the bell housing on an 1994 jeep Cherokee 4.0?
The bell housing is the front part of the transmission where it bolts to the engine. The bell housing surrounds the torque converter and flywheel.
The clutch went out in your 2001 eclipse gt and you can't get the transmission to break free from the bell housing Any suggestions?
why would you want to braek the bell housing free from transmission ? the bell housing needs to be removed to replace clutch, so remove bell housing and transmission as one unit.make sure starter motor is removed. usually blts the secure bell housing and transmission toether can only be reached from inside bell housing after bell housing and transmission are removed from vehicle
Where is the bell housing on 1999 dodge ram truck 5.2L?
The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.
Where is a bell housing on a 1999 grand Cherokee Laredo?
The bell housing is between the engine and the transmission.
Will a ford 302-351w bolt to a 300 six cyl 4 speed bell housing?
The Ford 302 engine will not bolt to the 300 six-cylinder bell housing. A new bell housing or a Bell housing modification kit will need to be used.
Where is the clutch slave cylinder located on 1993 jeep cherokee?
Inside the bell housing.Inside the bell housing.
What transmissions are compatible with Toyota l engine?
I think you have to have a diesel specific one from toyota. Part of the bell housing is built into the cast iron body of my diesel transmission. Gasoline versions I've seen have the full bell housing section removable fron the transmission body. The main issue is having the starter motor on the opposite side of gasoline engines. Hope this helps, Ben
