0
What are the Timing belt settings for fiat punto 1200cc 16valve?
Wiki User
∙ 13y ago
There are no timing marks but pins that are put through the head and into the camshaft locking it in the right position. They are dealer parts but you can get aftermarket ones. The crank is then positioned using a rod down the spark plug hole. Again this is available aftermarket. There are 2, one for cyl 1 and one for cyl2
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Flat punto 96 1200cc touqe settings for cylinder head bolts?
The torque settings for a 96 Fiat Punto 12cc for cylinder head bolts are 30 NM at 90 degrees. Then an additional 90 degrees.?æ?æ
Where is the timing marks on punto 1.2 have you picture?
what is the cost of replacing a combelt on a punto grande
Timing chain broken on Fiat Punto diesel 2006 - Is this a common problem?
i have a 2006 grande punto that timing chain snapped at 72000 miles
Where do I find the timing marks for a 1998 Fiat Punto 1.2 16V Sporting?
there is no timing marks
Diagram the firing order for a fiat punto 1200?
fiat punto firing order 1342 from timing belt end
What are the rocker cover torque settings of a fiat punto?
8-10Nm
What is the timing sequence for a Fiat punto?
If you mean the firing order it is 1342.
What are the timing marks on a fiat punto active sport 2003?
The timing mark on a Fiat Punto Active Sport 2003 is through the hole of the bell housing. The bell housing is under the area of the battery of the vehicle.
Fiat punto timing belt broken how much to repair?
about £700 not cheap!
What are the cylinder head torque settings for a fiat punto 55s?
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
What are the cylinder head torque settings for a fiat punto 1.1 55?
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
What are the Cam shaft torque settings on punto 8v?
I Believe They Are Around 40-48 Newton Metres
