The information for a 1993 Sable 3.8 is in the below cited "Related Question".
Definitely worth double-checking those specs - try Autozone's online Chilton's repair linked below.
Here's for a 2001 Windstar 3.8:
Torque Sequence
-----------------------
Frt | 7 3 1 5 |
Of | 8 4 2 6 |
Engine -----------------------
Step 1 - Torque to 14 ft/lbs
Steps 2 - Torque to 29 ft/lbs
Steps 3 - Torque to 36 ft/lbs
Perform following 3 steps on each bolt, before moving to next bolt in sequence
1) loosen 2-3 turns
2) if long bolt: Torque to 30-37 ft/lbs if short bolt: Torque to 15-22 ft/lbs
3) turn 175-185 degrees
Proceed to next bolt in sequence
Recheck final torque in sequence
the torque is the especific tighten that the bolts need in a specifical sequence: in a 3.8 lt. is executed as follow: step1- 15ft-lb. step2- 29ft-lb. step3- 37ft-lb. and step4 loos each bolt 2 turns and tighten until last torque specificated and very important is do that in the specific sequence .(do not loose all the bolts at the same time) intake maniful side 7 3 1 5 8 4 2 6 exhaust maniful side I hope this help you to see the sequence .
whats the torque odn a 2000 ford windstar 3.8 connecting rod
Tighten in a star pattern to 95 ft/lbs.
The head bolt torque specs of a 1985 3.8 Ford Ltd. is 50 to 55 ft lbs. This 65 to 71 Nm belongs to a 6-cylinder torque sequence engine.
the torque specs for the 5.4 is 350ftlbs of torque
whats the ring gear torque specs in a 10.25
24 ft. pounds
torque specs for rod and oil pan on 2005 4.0
Tighten front axle wheel hub retaining nut to 157-212 ft. lbs
ford f150
Torque specs for what part of the engine? There is torque specs for everybolt under the hood, some don't need to be used but some are critical
What are the intake manifold torque specs for a 1998 ford f-150 xlt
What are the torque specs for 99 ford ranger 3.0L intake manifold?