answersLogoWhite

0


Best Answer

3.1L v6 Engine First Step ----- 41 Ft-lbs Second Step ------ Rotate an additional 90-degrees (1/4 turn) and recheck removal and instalation are the same. Start with the bolts in the center and work your way out in a cross or X pattern. be sure to put some type of sealant on the bolt threads.

User Avatar

Wiki User

โˆ™ 2007-08-08 16:58:57
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: What are the head torque specifications for a 1990 Chevy lumina?
Write your answer...
Submit
Related questions

What are the engine torque specs for a 1990 Chevy Lumina 3.1L?

180 lb.feet of torque, for the 140 horsepower 3.1 litre v6


What are the torque specs for a 1990 Chevy lumina head bolts?

3.4 litre cylinder head torque is 37 ft lbs +90 degrees


What make a 1990 Chevy Lumina Car cutoff?

what make a 1990 Chevy. Lumina Car cut off when make a complete stop.


How do you change a turn signal on a 1991 Chevy Lumina?

how can i change the turn singal on a 1990 Chevy lumina


How do you unlock a 1990 Chevy Lumina?

with a key


What year did Chevy Lumina come out?

1990


What is wrong if your 1990 Chevy Lumina won't crank?

My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.


Is there a fuel reset button on a 1990 Chevy Lumina?

No.


Where is the fuel filter located on a 1990 Chevy lumina?

On my Chevy lumina it is located right by the gas take on the right side of the car.


Does a 1990 Chevy lumina 6cyl have a timing belt or chain?

The 1990 has a chain. The 1991 has a belt.


What engines fit in a 1990 Chevy Lumina?

The 194 3.1 only


How do you remove dash board to get to the radio in 1990 Chevy Lumina?

with a crowbar


Where is the signal flasher unit located on a 1990 Chevy lumina?

The 1990 Chevy Lumina signal flasher unit can be found beneath the drivers side dashboard. The signal flasher unit will be above the brake pedal.


Where are the motor mounts located on a 1990 Chevy lumina 3.1 liter?

There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.


Your 1992 Chevy Lumina is turning but want crank what is it?

My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.


Where is the O2 sensor in a 1990 Chevy Lumina Euro 3.1?

the o2 sensor for a 1990 Chevy lumina euro 3.1l v6 is on the down pipe for the exaust just below the manifold on the back side of the engine, by the firewall


Where is the gas filter on a 1990 Chevy Lumina?

It is right next to the fuel tank.


Does a 1990 Chevy Lumina V6 31 get green or orange antifreeze?

green


Would 15-inch rims fit on a 1990 Chevy lumina?

yes


Where is the fuel cutout switch located for a 1990 Chevy lumina?

Doesn't have one.


Head bolt torque for 1990 Chevy 350?

65 ft lbs torque


How many Ignition coils are needed 1990 Chevy lumina 3.1L?

I have a Lumina too and most commonly its 3 coil packs


What can you do if you bought a 1998 Chevy Ventura van from a dealer but he gave a title for a 1998 Chevy Lumina?

Check the vin #'s because in the 1990's Chevy called their smaller line of vans "Lumina" also.


Where is the MAT sensor located on a 1990 Chevy lumina 3.1?

in front of the air filter.


Where is the timing chain located on a 1990 Chevy lumina 3.1 liter?

in the engine block