answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What are the injector settings for a 3116?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you set injector pump timing on Mazda t3500?

how to set engine timing for mazda t3500


What are the cylinder head torque settings for a Cummings ISX 500?

170 nm on all the head settings injector setting is 8 nm


What is stc injector?

The STC injector enables the engine to have two timing settings, ie advance mode when in idle and retard mode when and during appliing load.


How do you remove a injector pump from a opel or vauxhall frontera?

u need a torque rench with your injector torque settings, they are on the side of the head built in in the 2.5 tds isuzu engine


What is 41 divided by 3116.?

0.0132


What are the release dates for The Bold and the Beautiful - 1987 1-3116?

The Bold and the Beautiful - 1987 1-3116 was released on: USA: 20 August 1999


How many gallons of oil does a 3116 cat hold?

6.6


What does 3116 equal?

3,116 = 1 x 3116, 2 x 1558, 4 x 779, 19 x 164, 38 x 82, 41 x 76.


What causes coolant in oil of a series 60 dietroit diesel?

Let's see...cracked head, cracked head gasket, cracked intake gasket, bad cylinder liner or cracked block, air compressor head gasket...if this was a Cat 3116 I'd also look at the oil cooler or an injector sleeve, but it's not so that's probably not it.


Why does your two stroke spit oil out the exhaust?

Oil in the exhaust is part of the two stroke design but if you have too much, you should check the fuel/oil mixture or the oil injector settings.


What are the c10 cat injecter settings and valve lash settings?

As per the service manual: With Cylinder #1 at TDC compression stroke, adjust #3 injector adjustment screw clockwise until it contacts the injector, then turn an additional 180 degrees and tighten lock nut. Repeat for #5 and #6. The engine then needs to be turned over 360 degrees until cyl. #1 is at TDC exhaust stroke. Cylinders 1, 2 and 4 can be adjusted. The valve lash settings (engine cold) are .012-.018" intake and .022-.028 for the exhaust.


Address?

Unit 11, 4 Aerodrome Road, Mt. Maunganui, Tauranga 3116 New Zealand