answersLogoWhite

0


Best Answer

# 77784ytrtytrcgcjchkjfjkhvlgujchx hhj # bbohvoyobi # kjhjj77776898 # 777987698897598698768y8 # 7u7iu9 # 89098798 # ## kkjhkjvu7778987889787698 ## 9098790 ##

# ioiuhioiuhihiohiohohoipokkkkhhoooooo

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the measurements of a 18 foot pool liner out of the box?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much sand do you need?

For what? Building a cove for a vinyl liner. Adding sand to a sand filter. Building a sand box. For the base of a pool. ????


How do you write measurements for a box?

The measurements for a box is written thus: length, width and depth.


What do cubic measurements measure?

Volume is measured in cubic measurements, such as m3, cm3, ft3, etc... .


How many billiard balls can fit in the 25 feet cube box?

If they are standard American pool balls with a 2.25" diament, you can fit 4,529,370 balls in a 25 cubic foot box.


Where is the fuse box located in a 1988 Cutlass supreme?

Under the glove box liner/tray.


What is the volume of a box 1 foot by 1 foot by 1 foot?

the volume of the box is 1


How many cubic inches a square foot?

"Cubic inches" is a measure of volume (three-dimensional) while "square foot" is a measure of area (two-dimensional). Therefore, the two measurements cannot be equated. However, you could ask "how many square inches are in one square foot?" Both measurements reference box (two-dimensional). The area is length times width, or one foot times one foot, or twelve inches times twelve inches. And 12 inches * 12 inches = 144 square inches.


When adding earth to an in ground pool do you pour it in the skimmer box or into the pool it self?

Add thru the skimmer box


What is the measurements of a average shoe box?

in meters or centimeters


I am installing new vinyl liner in a 18x36. how do I cut in the light when I get to that point?

Install the liner as per the instructions. Fill the pool to just below the pre cut hole for the light. now pull the liner up to the top, covering the hole. Fit your light housing and be sure to use silicone sealer on both sides. Once you have screwed it in place cut out the vinyl at the hole. See the movie on my site (the link is on same page) it shows the skimmer box which is the same procedure


High school rules are being used in this situation. If you have one foot in the batters box and the othere foot out of it are you in or out of the batters box?

you are in the box, you have to call for time.


What is the measurements of a poker box?

Poker boxes come in different sizes.