0
What are the possible problem for a ruud furnace overtempature switch keep tripping?
Gibbonsl
Bad hi limit switch or filter stopped up
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the problem of operating a on-load furnace transformer with center tap?
What is the problem of operating a on-load furnace transformer with center tap
How to Fix oil furnace?
Can you be a little more specific about the problem?
Is it a problem to connect a furnace humidifier to the hot water tank?
no
Why does my house smell like Vaseline and rotten eggs?
If your house smells like vaseline and rotten eggs, you may have a problem with your heating system. Contact your furnace serviceperson as soon as possible.
Furnace Repair ?
form_title= Furnace Repair form_header= Keep the temperature comfortable when you repair your furnace. How old is your furnace?*= _ [50] Has the furnace ever been repaired?*= () Yes () No Please describe the problem in detail.*= _ [50]
What is the problem with the iron produced in a blast furnace?
It is because it is not eco friendly
If you disconnect the tankless water heater on your furnace and have an electric hot water heater installed will there be a problem when the furnace runs to heat the house?
Not if it was disconnected properly
What is a problem with using iron straight from a blast furnace?
That iron is too brittle.
Would a bad millivolt thermopile keep the pilot light in a floor furnace from staying lit?
No, it will just keep your furnace from turning on. At least that's the problem I'm having right now with the bad thermopile in my floor furnace.
What is furnace ignition fault?
some problem with your furnace that caused a safety switch to trip on the inside of your machine. Usually on units it will have leds indicating what safety the machine tripped on.
How efficient is a mobile home furnace?
Mine is just like a slightly smaller regular home furnace. It keeps the mobile nice and warm,and I have no problem with it's efficiency.
Your furnace blows air when the thermostat is off you replaced the thermostat and the wires from the stat to the furnace but the problem still exists The furnace sHow is no error codes any ideas?
If the thermostat is wired correctly, it looks like that was not the problem. Not enough info to go much further than that other than to check the indoor fan relay. On an older model furnace look at the setting of the pointers on the fan/hi temp limit switch, if yours is an older unit with one of these I am betting that is your problem.
