200 horse power
pull the power lock fuse,,, my 94 cutlass did the samething..
Remove the power steering hose. Remove the power steering belt. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump on your 1985 Oldsmobile Cutlass.
apparently the window motor is bad and will need replaced.
more than likely you have a blown fuse in the fusebox for the power windows.
Yes it had power steering.
Yes what do I do
If the 1994 Oldsmobile with the 3.4 liter engine is the Olds Cutlass Supreme, the horsepower is 210. This car gets 19 miles per gallon in the city and 29 mpg on the highway.
The 1992 Oldsmobile Cutlass power window wiring diagram can be found in most service manuals. The wiring diagram can be obtained from most General Motors dealerships.
were is the power steering pressure switch on a 1988 oldsmobile cutlass 2.8 engine
steering fluid reservoirunder hood, passenger side, above serpentine belt.
Where the stick is.
Use a 10mm socket.
It isn't an easy job as you have to remove the inner finder panel.
it is located behind the power steering pump on the engine block
I think there are only a couple screws that hold it on a couple mounting brackets inside the trunk. You'll have to spin off the nut on the outside of the car that holds the antenna on there, too. The antena has a big wire that goes to the radio and another wiring harness that operates the power mast.
maybe you can look in the fuse box located under the glovebox and replace the electrical fuse.
Do throttle body service on vehicle Do idle/air control motor service on vehicle
check auto zone or Ur local savage yard. i have a Oldsmobile my self
There's no single replacable relay, power is fed through the switch and the electronics are inside the motor cover.
I have an '87 Cutlass Supreme Broughm and my rear-defog doesnt work either but my wipers are working. My power door locks, left signal light and power seat do not work either. My 4-way hazards do work though. I am hoping that someone can tell me which fuse this might be,
Remove the negative (black) cable from the battery. dissconnect any power wires running to the starter. remove two bolts located on the starter. Have someone help so they can hold the starter while you loosen bolts. When putting starter back in reverse procedure.
Check your RPO codes. If it has an U75 than it had a power antenna. If it has RPO code US6 it has a painted fixed antenna. There was only one style power antenna used from the factory.