0
22 to 23 suction 125 to 150 on head
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Operation pressures for r-134a?
45#
How do you charge a cooler with 134a?
12 psi
Add 134a freon to a Kia Sorento ac unit?
Using a set of a/c gauges put the blue hose on the low side (suction side) and the red hose on the high side (discharge side) to first check the pressures..... Add freon if needed and keep the pressures as follows.. low side readings between 30 to 40psi and the high side between 200 to 250psi depending on the outside temperature…………….
What is the r-134a refrigerant charge for elkay water cooler?
model ebfsa4-1b is 4.8 oz r143a
What should the high and low pressures be for 134A refrigerant on a freezer?
low side 25 psi high side 125 psi
What should the high and low pressures be for 404A refrigerant on a walk in cooler?
low 50 to 60 and high 250 to 300
My high and low pressure r134 readings are 90-95 each.what should the refrigerant r134a high and low pressure readings be?
If the pressures are always equal running, the compressor is bad and would need replaced
What causes variations in altimeter settings between weather reporting stations?
Altimiters work with pressure. Different pressures create different readings
Why do your air condition hoses freez up after the ac has been on for about twinty minets?
Did you do the air condition service yourself? If so did you add proper amount of 134a and compressor oil? What are the gauge readings on the hi and low pressure sides? (and include outdoor temp on the day you take readings)
What are the normal high and low side air conditioning pressures for a 1998 Cadillac Catera with a 3.0 engine?
It depends on the RPM at Idle speed your low side apr.. 40 and High side at about 150 at 2000 RPM LOW 22 High 230 if high is over 250 there is to much 134A in system at a amibent temp. of 70 degrees F. RPM and outside temp effects readings.
What is the operating pressure for a 134a freon system with a capillary tube on a backbar cooler?
Evaporator temp should be 15 Degrees. Gauge pressure should be around 15psig
Brittle deformation would be favored over plastic deformation in what?
High Pressures is the wrong answer. The correct asswer would be cooler tempeture.
