abs lol when the abs senses a skid it blocks the peddle preventing you from pushing it any further which would cause you to skid anymore
it does not work jam eti
The brakelight sensor is located on the brake switch, which is on top of the brake pedal and held on with a 14mm jam nut.
You don't have brake fluid There could be air in the system and it requires bleeding to rid it of air. If the vehicle is an older one, the master cylinder may be porus or the bore pitted. It should be resleeved or replaced. The seals could also be flat. Jam your foot down hard on the brake pedal. Is the pedal high? Does it sink to the floor if you rest your foot lightly on the pedal? www.powerbrakeandsteering.co.za
Under the dash where the brake pedal rests there should be a switch that the pedal hits when it is released, push it in with your hand, if the lights go out then it needs to be adjusted out toward the pedal by loosening the jam nuts on either side and threading them back. If the lights dont go out then that switch will need to be replaced.
Have you ever had to make an emergency stop from high speed, jamming the brake pedal to the floor and skidding to a stop? Have you ever been zipping along at highway speeds then spotted a lower speed limit sign and needed to slow down? What was the difference in the way you used your brake? ... You never bottom out the brake pedal. The same thing applies to making a smooth stop. The single thing that makes stopping smooth is to not think of it as stopping but to think of it as slowing down to a stop. If you want to slow down from 55 to 30 you don't jam the brake pedal to the floor, you ease on it until you have the speed you want. To stop smoothly do exactly the same thing - you are just braking gently, slowing down to zero. When you are at zero, you don't jam the brake pedal to the floor then either, you just keep the brake down far enough to keep from rolling. If there is any danger of rolling, then after you are at zero for a few moments, then gently press the pedal in the rest of the way. Stopping smoothly means that you might never bottom out the brake pedal. So the diffference in hard stops and smooth stops is more in your head than in your foot. Allow a lot more stopping distance then... Don't stop, slow down to zero. Try it!
rino can brake the ice
I would highly recommend that you do not make your own airsoft pellets. They might jam and or brake your gun.
No you cant jam skate on skorpion skates unless you want to brake something but you can jam skate in inlines and quads
a seal
Yes. It is now.
No But it has a tendancey to jam a little.
Try different ammo, then different magazines.