If the power has been disconnected: To normalize the window
1. push down on the power window switch and lower the window 1/2 way.
2. pull up on the switch until the window closes and hold switch for a second.
Per the owners manual pg 24. (2003 4 Runner)
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
have you tried pulling the EFI fuse
Type your answer here... Hello how do you reset the check engine light on a 2003 Toyota 4runner. Thanks
unhook the battery for about a minute or so, then reconnect!
Click the link.
Check your owner's manual. It's in there. So easy, I just can't remember for now.
There is no inertia switch. It will either be the relay under the hood or a short in power to the fuel pump.
Turn the 4Runner on, make sure that you are looking at the "odometer" miles and not the "Trip" miles. Turn the 4Runner off, hold the "reset" button, turn the 4Runner On and the "MAINT" light will blink 3 times. Release the "reset" button and the light will turn off. This worked great for me but the light flashed 5 times then went off. 2007 SR5 4WD 16,000 miles recently purchased from dealer hopefully there is nothing else wrong/ FYI the manual told me that the maint light is for oil change.
You will need to go to a repair shop and have them scan for codes. That will tell them the problem and when it is repaired they can reset the light.
The check engine light is reset with a scan tool after repairing the failure that caused the trouble codes.
fill all 5! tires to the proper pressure, even the spare will transmit and trip the light
on the upper left side of the guages there is a button labeled "reset". with the key off hold the button in, then turn the key on. the light should flash for a few seconds then turn off.