0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is rocker arm shaft?
A rocker arm shaft is normally a long shaft with rocker arms attached to it, that provides the pivet point for the rocker arms (newer Chevy motors).
What is arm shaft?
A rocker arm shaft is normally a long shaft with rocker arms attached to it, that provides the pivet point for the rocker arms (newer Chevy motors).
What happens if the rocker arm and shaft wear out on an engine?
Rocker arms operate the valves that allow fuel into the cylinder and exhaust out. If they are worn then the valves won't cycle fully, reducing fuel admitted and so reducing power output.
What makes rocker arm come loose?
a worn camshaft or lifter,use of a non self locking nut, some heads the rocker shaft is pressed and not threaded into cyl head and can lift out of head. also a bent or worn push rod, and last a worn rocker ball and seat note these answers are for over head valve train. with over head cam setup. a worn cam or collapsed hydraulic tappet, or adjustable tappet was not installed properly a;so a cracked valve spring.
What would make a rocker slide off the valve?
Worn out rocker nut?
What causes a rocker to loosen?
Worn out rocker nut, stud pulling out, or bad cam.
Why causes rocker arms to come off?
Over reving the engine, ( to many RPM )The rocker arm nuts need replaced ( The locks are worn out on the nuts )The rocker arms are worn where they set on the valve stems.Need to check everything closely.
How do you remove the rocker arm studs on an 85 Chevy 350?
There probably "pressed in" so take a couple of old nuts or balls from the rocker arm, put the nuts on the shaft, then put the rocker nut on and just tighten it up, it willl pull the shaft out of the head. Good Luck
Why do rocker shaft bolts break on a ford transit diesel?
heat fatigue.
Why do your rocker arms keep wriggling loose after you tighten them 350 rocket?
Each rocker arm has a bushing beneath the rocker arm screw. When the bushing is worn out, the rocker arm will continue to loosen up.
What does it mean when you have a VTECH system malfunction?
this probably means you have a worn cam shaft or cam shaft or the arm that hits the cam shaft to open the valve is worn. this is internal on the engine.
What causes the manual transmission output shaft seal to leak on a Toyota pickup?
most likely worn output shaft bushing worn
