Changing a head gasket (or in your case, gaskets) is a long process. If you have to ask this question, then you probably do not have the tools and knowledge to complete the task. A service manual would be necessary for you to have the correct procedure and torque specifications.
I believe that if a gasket is employed, then the need for gasket seal in a tube is gone, however, your gasket should be torqued to manufacturer's specifications. Yet, it doesn't hurt to have both.
Sometimes a leaking valve cover gasket can be fixed by simply retorquing the bolts to their proper torque. If that doesn't solve the problem, the gasket will have to be replaced as per your engine manufacturer's specifications.
There are dozens of torque specifications, for the 2002 Saturn. A complete list of torque specifications, can be obtained from most General Motors dealerships
The specifications are 118 ft of torque per square inch. It also has This is at 2500 rpm's these are exact specifications.
First clean off any remaining gasket residue so that both mating surfaces are clean and smooth. Then put the new gasket in place, with gasket sealer as indicated. Put the two parts together with their bolts and torque to specifications.
what are the torque specifications for 2002 ford 4.0 intake manifold
go to your local library and see if they have the motor or car manuals with that info.
What is the torque specifications for Madza T 3000 engine
drain the oil from the vehicle, unbolt the oil pan, scrape old gasket from pan and crankcase. check the torque specifications for the oil pan bolts (shouldnt be very high). replace the gasket and oil pan to factory torque specs. put drain plug back in and fill with factory specs of oil.
There are dozens of torque specifications for your 1997 Acura 3.2 liter engine. A complete list of torque specifications can be obtained from most Acura dealerships.
Chevrolet Cavalier there are more than 100 torque specifications for your 2003 Chevrolet Cavalier. You can get a complete list of torque specifications from most Chevrolet dealerships.
what is the torque specifications for a toyota camry 4-cylinder valve cover
There are torque specifications for every bolt in a Toyota Corolla 1.3 L engine. The head bolt torque specifications is 70 pounds.
A complete list of Ford E3 50 torque specifications can be obtained from most Ford dealerships. The torque specifications can be found at many auto-parts stores.
In the manual
The 1997 Chrysler Concorde has more than 100 torque specifications. The head bolt torque specifications are 160 pounds and should be torqued in 40 pound intervals.
The Caterpillar C15 diesel engine torque specifications for the rod bearings is 35 pounds. The main bearing torque specifications is 350 pounds.
Torque specifications are different from motor to motor. These specifications state how tightly the head bots are to be installed. Correct torque insure that the head gasket is sealed properly and correct torque sequence insures that the head itself is not warped in the installation process. Refer to a engine repair manual (Chilton's, Hayne's, etc.) for your vehicle/motor for the correct specs and torqueing sequence. You can usuall find these manuals at your local auto parts store. Hope this helps.
1966 Ford Mustang lug nut torque specifications are between 75 and 115 pounds. A torque of 90 to 100 pounds is also an acceptable range.
There are more than 50 torque specifications for your 1984 Honda 200. A complete list of torque specifications can be obtained from most Honda dealerships.
For what part? Installation Torque? (Engine torque production is about 420 lb-ft )stock.