Want this question answered?
8-10Nm
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
£13
The torque settings for a 96 Fiat Punto 12cc for cylinder head bolts are 30 NM at 90 degrees. Then an additional 90 degrees.?æ?æ
The Fiat Uno 1.1 Fire (Fully Intergrated Robotic Engineering) motor is the same in the Fiat Punto 1.1. The torque settings as per Autodata is Camshaft carrier cap - M8 x 1.25 20Nm or M8 10Nm Camshaft gear - 70Nm Anything else, just ask
Punto 1.2 engine code 176A7.000 Torque Stage 1. 20Nm Stage 2. 30Nm Stage 3. + 90 degrees Stage 4. + 90 degrees.
It is important to know the head bolt tightening sequence and the torque of a vehicle. For the Fiat Punto it is 20nm, 30nm, 90 degree turn, 90 degree turn, then in order 8,6,2,5,10,7,3,1,4,9.
on the engine block on the right hand side follow the top radiotor pipe onto the thermostat itself
Fiat Punto was created in 1993.
The Fiat Punto is manufactured by the company Fiat. Fiat is an Italian manufacturing company. The manufacturing of the Fiat Punto started in 1993 and is still currently being produced.
i asume you know your spanners so yes it is a straight forward job. and to help you on your way the torque settings are Fiat Punto Fire engine Stage 1 30Nm/22LBf ft Stage 2 59Nm/43.5LBf ft