Two sets of bolts - small (pan itself), large (4ea, pan to tranaxle housing.
Pan bolts (small) are two lengths. The longer are across the rear. Two stage torque sequence, working center out in a crisscross pattern. Tighten all pan bolts first (first stage), then tighten again to final spec (second stage). NOTE THAT THESE ARE IN INCH-POUNDS, NOT FT-LBS
First stage - 57in-lbs
Second stage - 106in-lbs
Pan to transaxle - 4ea. Two at center, one each outer sides. Tighten center bolts first, then outer.
47ft-lbs
Good luck!
The torque specifications for the cylinder had, in your 2003 Kia 1.6 liter engine, is 120 pounds per square inch. The bolts should be torqued at 40 pound intervals.
what the torque spec for the cylinder head on a 2003 saturn L300
Chevrolet Cavalier there are more than 100 torque specifications for your 2003 Chevrolet Cavalier. You can get a complete list of torque specifications from most Chevrolet dealerships.
2003 SATURN L 300 front axle torque spec
what are the cylinder head and crankcase torque specs. for a 2003 Polaris 500
What is the torque specs for Head bolts for 2003 Johnson 4 stroke 140 hp outboard boat engine
Hi i wannw know the torque specifications of the water pump in a 2003 dodge magnum 4.7l.Thanks,eric.
Front axle = 55 lbf-ft. Pinch bolts = 9 lbf-ft. Rear axle = 80 lbf-ft.
A 2003 Saturn Vue of high specifications could have a price that ranges quite a bit. On average, this would cost around $5,000. As specifications rise, the price could climb as high as $6,700.
The 2003 Malibu hub bearing torque specifications are 40 pounds per square inch. You can ruin the bearing by tightening it too much.
the torque you want to put on the water pump bolts are about 60 foot pounds of torque.
You risk breaking the bolts, or crushing the gasket to the point where it will not seal.