0
What are the torque specs for pistons bolts on a 305 Chevy motor?
Wiki User
∙ 15y ago
Pistons don't have bots. More information is needed.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What are the torque specs for a 235 Chevy?
The torque specs for a 235 Chevy include main cap bolts of 100 - 110. Its bellhousing bolts are 45 - 55, flywheel bolts of 50 - 65, and rod nuts of 35 - 45.
What is the timing marks and torque value on the head bolts of a 2004 Chevy cavalier 2.2 motor?
i need the head bolt torque on a 04 chevi cavallier engine 2.2 DOHC
What is the required torque for a 1985 Chevy 366 motor for the main and rod bearings?
To what torque should the rod and main bearings of a 1977 366 GMC truck engine be tightened? The rods have 3/8" bolts and it has 4 bolt mains with 1/2" bolts.
What is the correct torque specification for Yamaha outboard motor?
Torque for 50 hp fore stroke casing bolts
What is the torque for the bolts holding the crankshaft for a 2.4 kia motor?
The crankshaft bolt torque specification is 240 pounds of pressure. The crankshaft bolts should be torqued in 60 pound intervals.
Directions on puting a ford 390 motor together and what ftlbs to torque the bolts?
How am I supposed to know?
What is the torque spec for a 1995 Cadillac 4.9 liter rocker arms?
torque specs on the bolts that hold the rockers on a 4.9 cadillac motor
Is a 305 Chevrolet motor the same as a 350 Chevrolet motor?
Not really. Exterior dimensions are the same, and everything bolts on the same, but the bore is different which requires different pistons.
What is the torque for the headbolts on a 1.6 liter motor on a 1989 Nissan Sentra 4-cylinder?
I have a 1.6 L motor, it was; torque to 21, then torque to between 51 and 54 lbs. completely loosen bolts then repeat tightening pattern above.
Chevy small block rocker arm torque?
A lot of manufacturers use a torque setting, but not Chevy. With the motor running, go to zero lash, and then 1/2, to a full turn from there.
How do you tighten torque converter bolts on a Chevy 305 transmission?
pull the dust cover off the transmission and the converter bolts are easily accessable from there. there are three nuts and bolts that hold the converter to the fly wheel. probably 9/16 head bolts. turn the motor by hand until you see one.... tighten it and rotate motor again by hand until you see the next... tighten it and turn it to the third... tighten it and then reinstall dust cover
What are torque specs for Chevy 350 big block?
First off, a 350, is a small block. And, if you are talking about the torque output of the motor, well, that depends upon how it is built, and, with what parts. Anwhere from 150 ft., lbs., to 500. If you are talking about the bolt torque specs, it varies from 35 ft., lbs., to 85, depending on which bolts you are talking about.
