Want this question answered?
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
Front caliper bolts 25 ft/lb Mounting bracket bolts 80ft/lb
33- Ft lbs.
Front caliper bracket to knuckle, 85 ft lbs. I also use a drop of blue "Loctite" thread locker on clean threads.
_________________________________________Front caliper bracket mounting bolt-148 ft-lb Front caliper guide pin bolt-74 ft-lb
not sure from your question which caliper bolts you mean. the caliper to mounting braket bolt is 63 foot-pounds (these are the two bolts per caliper that you remove to change the pads. They are a pin and pass through a rubber boot). caliper mounting bracket to suspension is 137 foot-pounds (these are the two bolts per bracket that you also remove if you are changing the rotor disk). the factory uses red loctite on them and they are a bear to get out.
The torque for the brake hose to the caliper mounting bolt is 35 ft. pounds. For the adapter mounting bolt it's 16 ft. pounds. For the adapter to the knuckle mounting bolt, the torque is 50 ft. pounds.
Torque specs for brake caliper bolts 2005 mazda 6
Front caliper mounting ( guide pin ) bolts---80 ft. LBS. Rear 1/2 tons 31 ft. LBS. Caliper mounting bracket bolts FRONT---129 ft. LBS. Rear 1/2 tons 148 ft. LBS.
The caliper mounting bolts, both in the front and in the rear, require 39N-m, or 28.9 ft-lbs of torque.
Try about 25 lb. ft. for the caliper bracket.
Tighten Caliper bolts to 25 Ft. Lbs.