If you mean for the stero, check at www.installdr.com.
It really depends if it already has the wiring harness installed. Some models have the wiring harness already because it was a factory option. If the wiring is there, then it is a piece of cake. If the wiring isn't already there then you are going to have fun turning into a electrician for a day and making it work anyways. Also make sure you get the correct year for the window motor since the door was changed slightly through the years of the Probe.
== == Try installdr.com. They have step by step and wiring diagrams for all most all vehicles. I know they have the probe. totally free
Find the short or break and repair it with butt connectors. The best tool for diagnosis and locating these faults is the Power Probe. Otherwise, you'll have to unwrap wiring and find it manually.
This site gave me some good information - all the wires seemed to match my '95 probe. http://www.aus-cartalk.com/probe/audio.htm
Yes, But there is A lot of work and parts to change too. Tranny wiring harness most accessories motor and trans mounts computer You pretty much need to take everything out from under the hood and the computer and wiring and change it from one car to the other.
Try looking for a Chiltons manual for the correct year of your probe, I own one for my 92 3.0L v6 and it's loaded with every wiring diagram you need for the vehicle.
No, they are completely different motors with different wiring harnesses, motor mount positions and transmissions.
you would need to get a new ecu that will go to the motor you are putting in, then also get the new wiring harness. make sure you map out the angle of the engine to get the max of horsepower and gas milage.
: AutoZone.com now offers some of the best vehicle repair information on the Internet for free! Their repair guides offer detailed information about your vehicle - everything from step-by-step repair instructions to wiring diagrams are included in each guide! : For Ford Probe wiring diagrams, go to: ; : http://www.autozone.com/Ntt,1994%20ford%20probe%20wiring%20diagram/shopping/allResults.htm
The thermostat is located on the right side of the engine looking in, in between the intake manifold and the air filter box, underneath the wiring. This is in a 1994 Ford Probe GT 6 cylinder
P0120 Throttle Position Sensor P0325 Knock Sensor This is codes that are telling you that the TPS sensor and the Knock sensors are faulty.Replace them.