Want this question answered?
Remove - battery cable Raise and support vehicle Disconnect the wiring at the top of the starter Remove starter mounting bolts Remove starter
First remove the battery from the vehicle. then remove the two 10mm bolts on the top side of the battery tray and the one on the bottom side and remove it. remove the positive wires from the starter. the nut is a 12mm. there are two 12mm bolts that hold the starter bracket to the top of the transmission. remove them. if it is a manual trnsmission, remove the two 12mm nuts hold the clutch cable in place. this is so the bracket on the starter will clear the cable with ease. then remove the two 14mm bolts holding the starter in place.
Is this the airplane? Remove one battery post connector. Remove wire connections from starter. Remove mounting bolts. Remove starter. Clean the bolts and starter hole of any dirt or grease. Install new starter with cleaned bolts and reinstall wires and battery connection.
disconnect power from battery, remove wires connected to starter, remove bolts from starter (usually 2), remove starter.
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
where are the two bolts located on the starter?
Disconnect the - battery cable Remove wire at top of starter Remove Starter mounting bolts Remove starter
Disconnect the negativebattery terminal, starter is accessible from under the car passenger side, it bolts into the transmission with 3 bolts. Disconnect the wires from the starter, remove the bolts and reinstall new starter, reconnect wires.
First disconnect your batteries then mark all wires on starter so you know where they go on the new starter. Then remove three bolts and bam do this in reverse order and your done!