put key in ignition turn to first notch and press the remote either open or lock
tried both set of keys and the remote won't lock or unlock doors. Is this a fuse prob?/
I have heard that this worked, so I tried it and sadly, it didn't work.
Have you tried Star-Unlock?
You cant i tried and tried and i could not do it.
Have you tried to put it back? It may just work, if you want to replace the radio I would bring it to the dealer
1376 worked for me on my Atlas OCAP DVR-1056. I couldn't get it to work until I managed to unlock the preprogrammed CBL setting (locked to Pioneer apparently by TW Cable)
Of course you can
I read this on another website,but have not tried it: To program a replacement remote: cycle the ignition switch to the run (not start) position and back to off three times or until the door locks lock and unlock by themselves. Then, right after they do that, with the ignition switch in the run position push the lock or unlock buttons on both remote controls. This should do it. If it doesn't work then you have to go to the dealer. Good luck !
Try This: Press and hold the drivers side power UNLOCK button. Insert key into the ignition, Turn it ON, OFF. Repeat this step twice. At this point the power door locks should cycle to indicate the vehicle is in program mode, ready to accept programming. Press and hold the LOCK and UNLOCK buttons on the transmitter. The power door locks should cycle to indicate successful programming. Turn the ignition ON to exit program mode. I tried this on my 2002 Trailblazer, this did not work
This worked on a Mazda6 and a RX-8. 1. Open Drivers door and leave open. 2. Lock and unlock the drivers door using the power lock switch on door panel. (not sure if this is required) 3. Insert key into the ignition. 4. Turn key to the ON and OFF position 3 times in 10 seconds. Leave key in ignition. ( i have seen others say 24 seconds for 4 & 5 combined) 5. Open and close drivers door 3 times ending with door in the open position. (you can depress the door switch instead) 6. Door locks should respond by locking and unlocking. 7. Press any button on remote 2 times. Doors should lock and unlock. 8. If programming a second remote press any button 2 times on it and door locks should cycle again. 9. Remove key from ignition and door locks will cycle again. 10. Test remotes. I just tried this and it also works on Mazda MPV....Thanks!
you can't unlock regigigas i tried the Pokemon locater and it said that regigigas is not on any maps o.o
No, they do not because I have tried it. by:Richard_90