answersLogoWhite

0


Best Answer

Try unlocking the vehicle at the front passenger door. This will disable the security system and shou8ld allow you to start the vehicle.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What can you do to unlock your Cherokee 1993 it start and after 3 seconds goes off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1993 jeep grand Cherokee that shuts off 3 seconds after you start tried to lock and unlock both doors.still wont start help please?

im not shure but its probably the arlam that's the 1st year they put it on and it sucks


How do you start a 1993 Jeep Grand Cherokee Limited after the battery has been disconnected?

Using the ignition key, lock and unlock the drivers door. This resets the car alarm which disables the ignition. The car will now start.


What would cause a 1993 Jeep Grand Cherokee to start stall and then restart?

usually the factory alarm


Will a 1993 Cherokee motor work in a 1991 Cherokee?

Yes


What can you do to solve the problem if your Cherokee 1993 start but after 2 seconds goes off?

Try this.check the ignition ballast resistor on driver side firewall, its a white block with 2 wires connected. they break easily and the wires can fray or disconnect. jeep will start but die almost immediately if not connected or broken.


Does the windshield for a 1994 grand Cherokee fit in a 1993 Cherokee?

Yes


What years of Jeep Grand Cherokee transmission interchange with a 1992?

None, there wasn't a Grand Cherokee until 1993None, there wasn't a Grand Cherokee until 1993


When was Jeep Grand Cherokee created?

Jeep Grand Cherokee was created in 1993.


1993 stalls need to jump start runs for week same thing jeep Cherokee?

Sounds like an alternator that isn't charging.


Will a 1993 Jeep Grand Cherokee transmission fit on a 1993 Jeep Grand Cherokee Limited?

If same engine and transmission models, yes.


Would a 1993 Jeep Cherokee wheel fit a 1996 Grand Cherokee?

YES....


How do you manually retrieve fault codes on a 1993 Jeep Grand Cherokee Laredo?

Turn key to off-on-off-on-off-on within 5 seconds and watch the odometer. It will display all of the codes flash "end" at the completion. A 1993 will flash the check engine light in two digit code numbers. The odometer trick didn't start until about 2001.