0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you use stop leak to seal a pin hole in radiator on a 1998 grand prix?
For a temporary repair, yes and use as directed.
What constraint would you use to place a pin in a hole?
The circumference of the pin could not be greater than the hole it is placed in. Also, it must be the same shape as the hole.
How do you remove a stuck rear main oil seal from an older engine?
drill small hole in old seal use sheet metal screw drill small hole in old seal use sheet metal screw
If your car has a hole in the radiator close to the top of it but it is not leaking is this bad?
If it is a pin hole try using Bars Leak. If it is larger try using JB Weld to seal it. If you use jb weld, be sure the surface is clean and dry and give it plenty of time to cure.
What constraint would you use to place a pin inside a hole'?
Tweezer constraint
What constraint would you use to place a pin inside a hole?
Tweezer constraint
Kitchen faucet does not turn on at first and after a few seconds it will start running?
Some faucets use the water pressure to open the seal after it has been released by the handle. It may be that the seal is tight and slow to move after it has been released. One other thing to check, is your water pressure ok at this faucet.
State the effect of the use of multiple pin hole on the image formed in a pin hole camera?
Formation of multiple images on the Translucent screen and hence a blurred images due to overlapping of such images on the screen.
How can you see a solar eclipse?
You could use welders goggles. Or you could use a projector such as a pin hole projector.
How many gallons of water does a kitchen faucet use?
The faucet itself does not use any water. The rate at which the water leaves the faucet is dependent on the make of the faucet.
Where is the hole in the firewall on a 2000 Camry sedan to run a power wire from the battery to the amplifier?
there is no specific hole for this. use an existing rubber seal in firewall. take thin screw driver and insert in seal , stretching seal enough to push wire thru. seal will close around wire when you remove screwdriver
What what is the geometric term of tip of a pin?
a point, dot, hole, vagina you can use any of those 4
