What cause your 1985 caprice 305 motor to stall when you hit the gas at a stop light?

Carbon buildup can keep a motor from firing and cause an engine to stall.

yes..a bad oxygen sensor can/will make your car stall at idle speed

Is your clutch bad or wearing out ?

There are a couple of reasons a 1991 Chevrolet Caprice may stall out. The car may need a new distributor cap or the plugs may need changed. A mechanic will be able to determine the causes of the stalling car. ...

You can make a motor stronger by always checking the engine, checking the oil, and brake light functions. Makes sure that you drive safely and do not stall it. ...

If it works but not on all speeds or is almost making the car stall at idle if you turn the a/c on at a light Than its probably the fan motor resistor pack its $25-$30 at autozone and real easy and fast to replace. ...

no but in most late models your check engine light come on

Check the Park Avenue EGR valve for a clog. A clogged valve can cause a rough idle and stall at a light. ...

throttle position sensor located in the top part of the carb

The AC pump is bad. When the AC is turned on the pump tries to turn, because it is bad the extra strain on the motor causes it to stall. Be carely this can break or through a belt. In short its like putting a "brake" on your motor. ...

It is possible. It is possible.

Yes, that is one of many possibilities.

No. Well, maybe in an extreme case assuming you can't push the vehicle in neutral and you have a manual transmission..... ...

The alternator has nothing to do with stalling. When did you last replace the fuel filter? If the engine light is on then have a repair shop scan it and repair it. It is cheaper than guessing. ...

A problem in the fuel line could cause it to stall. On a stick shift, letting off the clutch too soon would cause the vehicle to stall. ...

1st try checking the EGR valve. If the EGR valve is sticking or leaking it can force too much air into the air/fuel mixture causing the motor to stall out. ...

Stoll condition of a motor or Stall torque is the torque which is produced by a device when the output rotational speed is zero. It may also mean the torque load that causes the output rotational speed of a device to become zero - i.e. to cause stalling.Stalling is a condition when the motor stops rotating.This condition occurs when the load torque is greater than the motor shaft torque i.e. break down condition.In this condition the motor draws maximum current but the...

A bad water pump can cause your car to stall if the bearing has failed or it is causing overheating. A seized bearing will put excessive strain on the engine and stall it out. ...

No. The water on the road won't make your vehicle stall.

stall at a higher airspeed.

Fast idle motor defective.

A motor with a totally blocked exhaust will start but immediately lose power then stall. ...

This is when the rotor (Shaft of the motor) Stalls, normally due to overloading, bearing failure ...

Is it low on Anti-Freeze? That is a known issue for a car to stall!

Possibly if the bearing is bad it will freeze up and stop when the bearing gets hot from friction. ...