ummmm you fried it
poor battery cable connection
may be you have the wrong battery, may be the battery is good with size, and amps, but some models have the connection on the inverse side where you need, then you must to look fot other battery with same size and amp. but with the connection on your right side, I hope this can help you
Have the output of your alternator checked,it should put out 14.5 volt. Also check the battery connection to virify that they are clean.
To replace the distributor wire on a Toyota Previa, first ensure the engine is off and cool. Disconnect the negative battery terminal to prevent any electrical issues. Remove the distributor cap by unscrewing it and gently pulling it off. Then, detach the old wire from the distributor and the ignition coil, and replace it with the new wire, ensuring a secure connection before reassembling the cap and reconnecting the battery.
If you reverse the connection of the battery charger you will discharge the battery. You may be able to correct the connection and charge it properly, or the battery may be ruined.
Remove the positive battery cable from your 1994 Firebird battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Repair the alternator to battery connections or replace the battery.
do you have to reset computer after changing battery in 2003 745li
Battery light usually means alternator not charging. Most common solutions would be be a bad alternator, bad connection, or loose alternator belt. If the battery and alt test ok than check the connections to the alternator and battery.
try changing your fuel filter.
Battery light usually means alternator not charging. Most common solutions would be be a bad alternator, bad connection, or loose alternator belt. If the battery and alt test ok than check the connections to the alternator and battery.
First unhook the battery. Next, remove the distributor cap and unhook the wire that runs to the coil. Then loosen the distributor clamp (10mm nut) and pull the distributor out.