if yours is a manual make sure the clutch is not dragging, if its not and your problem is purely at idle look for any vacuum leaks(cracked /missing hoses) you can do this by spraying carb cleaner around the intake fittings while the motor is running, if a leak is present the carb cleaner will in-richen the fuel mixture and the idle wis raise. if you sprayed evrey fitting and havent found a leak then its time to look in to what controls the motors fuel.
MAP
TSP
AIC
these three components work together to create the ideal fuel to air ratio for the motor in different conditions.
first pull off the air in take hose, be sure the butterfly valve moves freely, clean area with the leftover carb cleaner. now that you have located the butterfly valve find the AIC (air idle control ) is bolted just below the butterfly valve. over time carbon and other foren objects clog and block that valve, remove and cleane with carb cleaner, re install the ICA and most of the time this is the solution
good luck
-Michael
wheel balance
sensor or belt
sensor or belt
If the car is starving for fuel or air (low power at idle), the car will stall while turning.
Oil in the distributor.
2001 sienna stall while just stop while driving. electric just cut out power, then switch can operated but idling roughling
There are several things that can cause your Jeep to stall while idling. The timing may be off or your fuel filter may be clogged.
YOUR car will Immediately sputter and backfire, followed by a complete stall. Your timing belt (or chain), is directly synchronized with the cam shaft.(crank shaft turns cam shaft, via belt or chain)...Tom
timing belt just replaced one today
A loss of power on a Toyota Celica GT while accelerating can be a number of things. The timing might be off. The coil pack might be allowing for a misfire. There might also be a bad Oxygen sensor or bad distributor.
For starters change the fuel filter
it maybe just a timing problem