Check the coolant level in the reservoir, it may be empty.
if an element is constantly expanding and contracting (if you keep switching the hot water heater off and on again) all the time it causes cracks and over time the water leaks into the element causing it to short which means you have to replace it.
Heater. Core
Firstly a water heater is a concealed unit and all joints are meant to be leak proof. Sounds like there is a leak somewhere in the water heater. Get a plumber to investigate and fix where necessary.
There are a number of causes as to why a hot water heater would stop heating the water. It could be due to a fault in the circuit breaker or a problem with the element, limit switch or thermostat. Unless you know what you are doing, you should contact a qualified plumber or electrician to rectify the issue.
You are running the water heater out of hot water faster than it can heat the incoming cold water.
Check where this rusty water is coming from. There are many possible causes.
Your heater core is leaking you probably also noticed the heater may not be working as well.
Empty battery, water, stain, dust or somebody threw it at the floor.
Either the heater core is leaking, the windshield is leaking, or there is a leak around the cowl. If the water tastes sweet it is a leaking heater core.
By Andreina Urdaneta A clean water heater will heat and maintain water better and last longer. Once a year, flush your water heater, and in extreme hard water areas, at least twice a year. If you feel up to the challenge, here are some tips to help you in a basic cleaning. 1 Turn the water heater and the cold water supply to the water heater off. 2 Hook a high-quality garden hose to the drain valve, and place the other end in an area where hot water will not cause damage. 5. Open the drain valve. 6. Disconnect the cold water pipe on the top of the water heater. This step will let air into the water heater so it will drain. When the water heater is empty, close the drain. 8. Pour tile cleaner into the cold water, leave for a couple of hours and drain the detergent out of the tank. 10. Reconnect the cold water supply to the water heater. Open the cold water valve and let the water heater flush for a couple minutes. 12. Close the drain valve and open the hot water faucet nearest to the tank, and let the water heater fill. 13. When water starts to come out of that faucet, reopen the drain and let the water heater continue to rinse. After all the air is out of the water heater, turn it back on. Take care of your water heater, and it will take care of you. If you keep ignoring the task, your water heater may just leave you in the cold.
When you call 911 water heater Katy, ensure that you will get the water heater repair services that include;Residential Water Heater repairs, Commercial Water Heater repairs, Water Heater Installation, and Replacement, Electric Tankless Water Heaters repairs, at the time your water heater is leaking from the top, leaking from the bottom, or when there is no hot water comes from the heater, or there is hot water, but it is not enough, call the trusted water heater repair service in Katy, TX, calling 911 water heater Katy.