0
What causes brakes to drag eventually lock up and get hot on a 1989 voyager pedal also get very hard?
Wiki User
∙ 17y ago
You might want to replace the front rubber brake lines. On the inside of the brake hose they disintegrate, which causes the fluid to go thru the line but not return when pedal is pressed. If it releases when car sits and cools off .then this is probably the culprit.GOOD LUCK
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What causes hard brake pedal on 1993 Geo Metro?
try bleeding the brakes or checking the fluid
What causes the brake pedal to feel soft?
Air trapped in the brake lines. Bleed your brakes and that will solve the problem.
Does a trick bike need pedal brakes?
Yes, because as an bmx rider i aslo do trick ridding and we do need pedal brakes
What causes brake warning lights to stay on in Ford Escort?
There is a piece behind the brake pedal that brakes, it is round and blue, but I do not know what the piece is called.
What is a synonym and antonym for pedal?
brakes and handlebars
Does the BMX bike has breackes?
most bmx bikes dont have front brakes now ans if you pedal backward and it has pedal brakes its not a bmx bike
To dry wet brakes what should you do what?
you should gently press the brake pedal and gently press the gas pedal, the increase friction will dry the brakes.....
What causes squeaky brakes?
If your brakes are squeaking, that means the pads are wearing thin. When you hit the brake pedal, the pads push against the rotor to create friction and slow down the vehicle. Over time these pads wear away, and when they get thin enough they make a squealing noise. This noise notifies you that you need to have new brakes installed as soon as possible. If you keep driving without replacing them, the pads will eventually wear down completely and then every time you hit the brake pedal metal will scrape against your rotors. This can be very damaging and dangerous, so when the brakes start to squeal have them looked at right away.
What causes the brakes to give when i push the brakes the pedal slowly goes down after a few seconds?
Master Cylinder seals are defective. Replace the Master Cylinder ASAP. Stop driving the vehicle until you have this repaired. The brakes can fail completely at any moment.
How do you do the brakes?
place pressure on the pedal with your foot (preferably)
What is the brake pedal reserve distance?
It is the distance between floorboard and pedal top, when the brake pedal is fully depressed (after applying brakes).
What is disc run out?
A disc brake rotor with excessive run out is a warped rotor which causes a pulsation in the brake pedal when the brakes are applied. A certain amount of run out is acceptable.
