0
Static pressure.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Orbit Sprinkler Valve?
form_title= Orbit Sprinkler Valve form_header= Keep your lawn healthy with a sprinkler. Do you need to replace a sprinkler valve?*= () Yes () No How many valves do you need?*= {1, 2, 3, 4, 5, More than 5} How old is your current sprinkler?*= _ [50]
How do you wire a sprinkler control valve?
In the open position
What causes chugging in a 2004 Subaru?
Peer pressure at parties, usually.
What causes chugging in Chevy Express 4.3 liter at hiway speed?
An alcoholic with an open container.
When checking a sprinkler system a security officer should do what?
ensure valve is closed
What is a Fire Sprinkler alarm valve?
Some fire sprinkler systems have a valve for testing the water-flow alarm by allowing water to flow to the alarm, or through the alarm-sensing pipe, without activating any sprinklers in the rest of the system.
Why is the lawn sprinkler head leaks water when the main water valve is shut off?
After a main water valve is closed the system's PVC pipes are still full of water and will drain to the lowest sprinkler head until the system is empty.
What is the voltage to a sprinkler valve from the control panel?
Most common North American garden sprinkler systems use 24 volts AC. The control units usually plug into a common 120 volt AC receptacle. Inside the control unit there is a transformer that reduces the voltage from 120 volts to 24 volts AC. If you look on the side of the sprinkler valve coil you will see the voltage and the amperage draw of the coil. It is the amperage draw of the coils that determines the number of sprinkler that should be on one sprinkler branch from the main water manifold. The total amperage of the circuit determines what the size of the wire should be to control the sprinkler coils.
What are some causes of chugging and hesitating in a 2001 integra GSR?
Chugging and hesitating can be caused by several problems with the Integra. Check for proper fuel pressure, as well as proper engine timing. Check the computer for any engine codes.
How can you use chugging in a sentence?
harry was chugging for water because he was thirsthy.
How do you reduce or increase water pressure on a grass sprinkler?
With a pressure booster pump or a Pressure reducing valve
How do you install a sprinkler system?
There are two main methods of sprinkler system installation: open trench and pulled pipe. Open trench typically uses PVC pipe and pulled pipe typically uses poly pipe. Other than the pipe and fittings, the main difference in installation will be that the pulled pipe system requires a hole and saddle tee at the location of each sprinkler head. The steps for installing an automatic sprinkler system using an open trench method are: 1. Start with a good sprinkler system design (try searching "sprinkler system designer" for support options) 2. Make sure that you have all necessary tools, equipment, and permits 3. Have Blue Stakes mark all utilities prior to any digging 4. Install a backflow prevention device according to code 5. Place flags at the location of each sprinkler head 6. Mark and dig all trenches and valve manifold locations 7. Build and install valve manifolds (preassembled valve manifolds can make this easier) 8. Connect mainline pipe from water source connection to valve manifolds 9. Lay lateral line pipe from the valve manifolds to the location of each sprinkler head 10. Install tees and swing assemblies for each sprinkler head and flush lines 11. Connect sprinkler heads to swing assemblies; set head to level with ground 12. Install sprinkler timer/controller and connect sprinkler wire from timer to valve manifolds 13. Install nozzles on sprinkler heads 14. Install valve boxes (as required) and backfill all trenches 15. Run a zone by zone test and adjust nozzle patterns
