It is on the same circuit as the brake lights, but if they are not working, and the bulbs are good your switch needs cleaning or adjustment.
Attempt this first since the switch costs nearly $300 bucks.
On the passengers side of the trans just behind the bell housing there is a fan shaped switch, loosen the 12mm bolt ( smaller of the two, and rotate the switch while a friend checks the lights. this problem is usually accompanied by an occasional inability to start the vehicle, but can be cured by jiggling the shifter.
While adjusting the switch make sure that the vehicle will start in park as well, remember to block the wheels while testing the back up lights, engine off, key in run but not start, shifter in reverse, move switch until lights come on.
Once you find this spot, hold it in place and have your helper check to make sure it will start. This may take several tries to get both working correctly.
If you have no luck the switch may be dirty, this happens a lot. Hold the post to the bottom large bolt still while you loosen the nut, then remove it, then remove the 12mm adjusting bolt on top, remove the wire connector and pull the switch away, remove the bolts on the switch and separate the halves, use electrical contact cleaner and maybe some q-tips to clean all the copper connections completely apply di-electric grease and reassemble, refit to the trans and readjust so all functions work, this switch controls back up and start safety.
Caution! always hold that bottom bolt while tightening the large nut, this is connected to the gear adjuster and you could damage the internals if it isn't secured while you do it.
you may have your brake light socket and your back up light socket in the wrong holes. Or you have a short but that would probably leave you with a blown fuse and no lights.
did you check the reverse switch on the trans ?
you got to replace to light bulbs
what causes the battery light to on a 2005 ford expedition to come on?
It probably has something to do with the switch.
my trac off light comes on in my 2002 cavalier then the car cuts off, but will start back up minutes later then the check engine light will come on and they both stay on
To shift the recon into reverse push the red button at the right break lever labeled "R" down and pull the lever back. Then shift down using the down arrow on the electric shift. Reverse light should come on and back you go.
because the engine is cold. after it warms up the light goes off. Cute! But what causes the blue light to come back on even after you've been driving for a while?
The reverse lights automatically come on as you put the car into reverse , if they are not coming on your most likely problem is the fuse or bulbs
motion of anything
Remove the connector from the back of your indicator light assembly. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out. Reverse the process to install your new lightbulb.
Normally caused by failed oil pressure sensor. It is located on the back of the block.