My 2007 cobalt also has this problem. The chimes and turn signal sounds come out of the speaker in the drivers door. If there is a bad speaker connection, or the speaker no longer works, you won't hear any chimes.
that chime is telling you that the door is open if you have owner manuel, you can find in manuel how to turn off the door open chime from working
Your sunroof is open. Go check it. Even if it's slightly open or tilted, you'll hear a single chime every time you open the driver's door.
There is no chime for the headlights or key in the ignition with the door open
You can unplug it. Its under the dash board
My 1995 Ford Explorer has also done that occasionally ( although I have removed the ignition key as soon as I open the drivers door , the key in ignition chime starts " going " ) What I do is put the ignition key back in and then remove it again and the chime will stop Give that a try
There is a small switch inside the steering column lock mechanism. When that switch fails it can cause the door alarm to chime. The chime is supposed to inform you that the key is still in the lock, but when that switch fails it can certainly cause the problem you described.
The chime may ring on a 2000 Mazda MVP if a door is open and the keys are not in the ignition because the car has a secondary alarm system that is letting the driver know that a door is ajar. If the door is opened while someone is sitting in the passenger seat it might go off before the person exits the vehicle.
Open door Turn ignition on press valet button on and off 3 times (you will hear chime) press lock button turn ignition off DONE!!
Most likely because you left your lights on. Every vehicle plays some kind of chime or warning when you open your door to leave your vehicle when you have the keys out of the ignition. This is to prevent you from leaving your vehicle unattended with the lights on, so you don't kill your battery.
Does the engine crank ? If not , does the underhood light come on when you open the hood or the door chime sound if the keys are in the ignition with the drivers door open ? If you don't get any lights / door chime etc. it could be a bad battery cable connection or a dead battery If the engine cranks and does not start , it's either not getting fuel or spark
1. Begin with the driver's door open. 2. Within 20 seconds insert the key in the ignition , 3 times, turn the ignition key to the run / on position, then back to off. slide the key out of the ignition until the door open chime stops sounding , Press the open door button 3 times located on the car frame. 3. You should hear a chime indicating the car is in programming mode. 4. You can now program exactly 3 fobs. To do this, press any one key on each fob twice, waiting for an acknowledgement chime between each fob. If you have only one fob, do it 3 times. If you have 2 fobs, program the first one once, and the second one twice. 5. Press the door open button once. The car should chime.
The door chime on a 2000 Ford F250 can be disabled by removing the fuse or pulling the wiring harness. The chime is automatically trigger each time the door is opened or is left open