The speaker wires for the 2007 Jeep Grand Cherokee are dark green and brown for the left front speaker and gray and brown for the right front speaker. The rear speaker wires are dark green and dark blue or violet on the left and gray and tan or gray and dark blue on the right.
Just hook the right colored wires up to the speakers. In truth, it isn't going to matter which side of the speaker they're hooked to. It'll sound fine.
make sure your wires are correct from the distributor or you will never start
speaker is black-, blue with brownish stripe + on power connector their are 4 wires ,2 of them are black,1 green,last is black with green stripe
the answer is YES, use a test light to find the + and - wires (should be one ground wire and two hot wires [one hot all the time for your clock & one hot only when the key is on]) in order to find which speaker is which, use a 1.5 volt battery to make a popping sound in the speaker (won't hurt the speaker) and then the solid color wire will be your positive & the wire with the stripe will be your speaker ground.
I would check the wires just behind the light. I had the same problem and the wires were broken a little just wiggle them as the lights are on.
The speaker wires on a 2005 Avalanche are white. Most automobile manufacturers use white wires for the speaker wires. After market speaker wires are usually red or blue in color.
Just hook the right colored wires up to the speakers. In truth, it isn't going to matter which side of the speaker they're hooked to. It'll sound fine.
To find your speaker wires, check your owners manual. You should find a diagram with the location and color of your speaker wires.
With your hands or possibly some type of tool.
go to www.commandocaralarms.com/wiring/1996/Jeep/Grand-Cherokee and it will have a chart of wires and wire location. i have a 1996 there all the same.
the answer is here www.installdr.com I had the same problem.
Not sure of the color, but I learned a trick all you need is a battery from a cordless drill. If you have the radio disconnected You can use the battery on the speaker wires just touch the wires to the battery and youll hear a sound .
Not enough info to answer. Please ask a new question and include year, make, and model.
yellow and brown
I know my Jeep GC has "coil on plug" ignition, so there aren't traditional spark plug wires, just low voltage.
There is no ground for any of the speakers in a car. You will find to wires that go to the speaker but NEVER have the speaker wires touch any body metal. If you tie any of the speaker wires to ground you will short out the amplifier in the radio. On Ford vehicles the radio outputs are what they call Bridged Tied Loads. The speaker wires are not referenced to ground or battery. If you wish to find out the phasing of the speaker just put a 9 volt battery across the speaker wires and the speaker cone will either advance or retrack. Do this to all the speakers and note what color wir was on the 9 volt battery terminal
this happened to mine it was to burnt out wires behind the dash