0
What command is used with RIP to propagate default routes to neighbors?
Wiki User
∙ 11y ago
ip
default-network
address
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Which command allows a router to advertise default static routes via OSPF?
default-information originate
Is it possible to use RIP V1 with default static routes?
At the foundrynet website there is detailed information on default static routes and instructions on how to activate RIP V1 defaults.Also, information on switching and routing.
Which command shows the administrative distance of routes?
what command allows you to configure an administrative distance
Which command will show the administrative distance of routes?
The "show ip route" command in Cisco devices will display the administrative distance of routes along with other routing information.
What are two ways that a router can learn of the paths to destination networks?
Update from other routersARP request from connected routers
What is the command on a Cisco router that will display all the routes the router knows?
show ip route
Which command used to trace the routes between two systems?
you can use the ping command. the syntax is open DOS and then type ping ipaddress of the host machine
In the great wall of chine trade routes were called what?
they had no trade routes because, they didnt want to trade with their neighbors (Mongolians). The Mongolians, even though were blocked by the Great Wall of China, found a way around it and still invaded.
Which cli command display the static routes in the routing table?
conf terminal Router#show ip route
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
Why dd Phoenicians choose the sea for trading?
phoenicians chose the sea for trading because phoenicia's overland trade routes were blocked by mountains and hostile neighbors.
What are the key characteristics of OSPF?
OSPF has the following features:Fast Convergence OSPF can detect and propagate topology changes faster than RIP. Count-to-infinity does not occur with OSPF.Loop-Free Routes OSPF-calculated routes are always loop-free.Scalability With OSPF, an AS can be subdivided into contiguous groups of networks called areas. Routes within areas can be summarized to minimize route table entries. Areas can be configured with a default route summarizing all routes outside the AS or outside the area. As a result, OSPF can scale to large and very large internetworks. In contrast, RIP for IP internetworks cannot be subdivided and no route summarization is done beyond the summarizing for all subnets of a network ID.Subnet Mask Advertised with the Network OSPF was designed to advertise the subnet mask with the network. OSPF supports variable-length subnet masks (VLSM), disjointed subnets, and supernetting.Support for Authentication Information exchanges between OSPF routes can be authenticated.Support for External Routes Routes outside of the OSPF AS are advertised within the AS so that OSPF routers can calculate the least cost route to external networks.
