At the foundrynet website there is detailed information on default static routes and instructions on how to activate RIP V1 defaults.Also, information on switching and routing.
30 Seconds
RIP is a routing protocol - a protocol (set of rules) that allows a router to exchange information, with other routers, about existing routes.
RIP Characteristics " RIP has the following key characteristics: RIP is a distance vector routing protocol. RIP uses hop count as its only metric for path selection. Advertised routes with hop counts greater than 15 are unreachable. Messages are broadcast every 30 seconds. The data portion of a RIP message is encapsulated into a UDP segment, with both source and destination port numbers set to 520. The IP header and data link headers add broadcast destination addresses before the message is sent out to all RIP configured interfaces.
To route a packet, usually an IP packet, a router compares the destination address to its (the router's) routing table. The router can get entries (rows) in its routing table in three different ways: (1) directly connected networks; (2) static routes (the route was configured manually by an administrator); (3) dynamic routes (the router learned available routes from a neighboring router, using a routing protocol such as RIP or OSPF).
Blu Ray Rip. Same as a DVD Rip but from a blu ray disc :)
ip default-network address
RIP v2 supports subnets of different sizes. So I guess it would be the router that can, or can not, be configured to summarize routes. (This would not be possible in RIP v1; the size of the subnet is implicit, it is not sent with the routing updates.)RIP v2 supports subnets of different sizes. So I guess it would be the router that can, or can not, be configured to summarize routes. (This would not be possible in RIP v1; the size of the subnet is implicit, it is not sent with the routing updates.)RIP v2 supports subnets of different sizes. So I guess it would be the router that can, or can not, be configured to summarize routes. (This would not be possible in RIP v1; the size of the subnet is implicit, it is not sent with the routing updates.)RIP v2 supports subnets of different sizes. So I guess it would be the router that can, or can not, be configured to summarize routes. (This would not be possible in RIP v1; the size of the subnet is implicit, it is not sent with the routing updates.)
RIP is a protocol used by routers to exchange information about their routing tables. In dynamic routing, a router learns from other routers about possible routes by advertising what they know. RIP is a protocol that can do that.
Instructs routers to ignore updates, for a specified time or event, about possible inaccessible routes.
RIP is used in dynamic routing.
Every 30 seconds by default in RIP version 1.
120
120
Up to 25 destinations can be listed in a single RIP packet.
* Manually set up a route in a dormant manner. * Stable. * Has no impact made by traffic and transmission failures. * Creates no traffic derived from routing protocols. = dynamic routing: = * Automatically sets up a route. * Can respond to the changes of the network. * Can automatically select the optimized route. * Can automatically select the backup route.
180 seconds
30 Seconds