answersLogoWhite
EGR Systems
Chrysler LeBaron
Ford Expedition XLT

What controls the egr valve on a 1988 2.5 Chrysler Lebaron?

345

Top Answer
User Avatar
Wiki User
Answered
2008-09-06 21:56:22
2008-09-06 21:56:22

The engine computer controlls it.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Where is the hydraulic reservoir for 1988 Chysler Lebaron convertible top?


You can find owner\'s manuals for 1988 Chrysler LeBarons online at find.com and amazon.com.


Front or rear.. disc or drum type..??????????


It is on the front of the transmission case.


Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.



They are screwed into the cylinder head, at the end of the plug wires.


The dipstick is on the lower front of the transmission on a LeBaron.


Hey Jermaine==It is at the rear of the engine. Follow the pos batttery cable. GoodluckJoe



The filter is located under the car on the passenger's side just forward of the rear tire.


On my 1986 Chrysler lebaron the fuse box is located in the glove box.Open the glove box and on the right hand side of it is a fuse panelAnswerOn most cars, the fuse box is located under the dash near the kick panel on the driver's side.


passenger side, under car, just behind pass door, in front of gas tank


It should be somewhere in the engine compartment, if it has been removed then you can try: http://minimopar.knizefamily.net/vacuum.html


Stalling can occur for several reasons. The first step in troubleshooting these cars is to check the fault codes.


To set the clock on a 1988 Chrysler Lebaron you start by pressing the "set" button while the radio is on and push the volume knob in. Once you see the hour number flashing on the screen, adjust by using "seek" and press the volume knob in once you set the hour and then it will go to minutes. Adjust the minutes using the same "seek" button and press the volume knob in and the time will be set.


no, I placed a 100w lightbulb underneath the oil pan


The fuel pump on the 88' leBaron is located in the gas tank. to remove the pump you need to remove the tank. but one common problemeb with this is the muffler is in the way so it might help to remove that secton firstIt is NOT required to remove Gas tank to change fuel pump.,,it is on the back of tank,,raise car on hoist and look at tank from rear..


It is a Proportioning valve. It controls how much pressure is applied to the brakes on each axle. During heavy braking this prevents rear brake lock-up.


the fender probably fills up with water. You need to make sure that the drain holes under the car are open. this shorts out the motors. then you need to access the motor and have it rebuilt or find a used one.


You can use Dextron II or Dextron III automatic transmission fluid. You could go to an auto parts store and get a container of power steering fluid but all it is is a Dextron trans fluid in a dif container.


It could be a 2.2L or a 2.5L. If the engine is original, and is a turbo it will be a 2.2L. If it is a TBI engine it is likely to be a 2.5. There are a few ways to check. The 2.5L oil pan will have a flatter bottom, the 2.2 pan will have a round bump near the center.


re:why won't my lebaron start. I left out some details.... It just quit starting one day. I replaced the relay fuse on the advice of a friend ,but it didn't affect it at all. The is no click or any sounds indicating that it is even trying to start. IF there is no click it sounds like starter or bad connection to starter Check wires to starter and battery posts for corrosion first





Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.