answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2010-02-09 22:08:46

wheel barings

001
🙏
0
🤨
0
😮
0
😂
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

How is a head gasket leak repaired on a 1998 Chrysler Sebring?

It requires replacing the head gasket.


How much should it cost to replace a blown head gasket on a Chrysler sebring V6?

The price to replace a blown head gasket on a Chrysler Sebring V6 should be around $1,000.00. The price can vary depending on where you have the repairs made or if you replace it yourself.


Where is the oil drain plug gasket on a 2000 Chrysler Sebring jxi?

It should be on the drain plug.


What would cause a leak behind the water pump on a 1998 2.5 Chrysler Sebring?

Water pump gasket, head gasket, water tube,


How much would it cost for a blown head gasket on a 2008 Chrysler sebring?

Expect to spend from $800 to $1200.


Do you remove the timing belt on a Chrysler PT Cruiser when changing the head gasket?

Yes.Yes.


Why would oil be coming out of the block area where you add oil and the spark plugs are on a 1997 Chrysler Sebring?

Possible failed valve cover gasket.Possible failed valve cover gasket.


What causes water in oil on a 2002 Chrysler sebring 2.7 liter motor?

Two likely causes are a failed water pump or a failed head gasket.


Why does your Chrysler sebring convertible go full throttle when you start it?

Air leak in upper manifold, use a double gasket, problem solved! throttle cable stuck,


How do you replace a head gasket located on a 1996 Chrysler Sebring LXI?

Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"


How does water get into the oil on a 2.7 liter Chrysler Sebring?

You have a blown gasket somewhere. Probably a head gasket. These 2.7 litres are notorious for the water pump bearing failures these water pumps are very expensive to get replaced since their timing chain driven


Why does a 1996 Chrysler Sebring overheat?

Causes include low coolant, inoperative radiator fan, plugged radiator, stuck thermostat, water pump malfunction, head gasket failure.


What are some reasons a 2001 Chrysler Sebring overheats?

Low coolant, inoperative radiator fan, failed water pump, restricted radiator, head gasket failed, stuck thermostat.


What would be the fix for a big oil leak above the exhaust manifold on a 1997 Chrysler Sebring 2.5L V6?

Valve cover gasket or spark plug tube seals are probably bad.


How do you replace a blown head gasket for 1996 Chrysler sebring 2.4L engine?

Remove intake and exhaust manifolds, and then remove the head. This is a major repair that should only be attempted by someone who is competent.


How do you change the spark plugs on a 1998 Chrysler sebring?

you need to take the intake maniflod off, and the 2 screws on the back of the manifold. total time 2.5 hours, replace intake gasket or reseal it...


How do you change a transmission front gasket if it is leaking on a 1997 Chrysler Sebring convertible 6 cylinder JX?

Take it to a transmission shop. Depending on what you mean by front gasket, it will probably involve removing the transmission. Again depending on what you mean, it is most likely an indicator of a bigger problem.


What would cause a knocking sound after changing the oil pan gasket in a 2000 chrysler voyager?

Something was assembled improperly. Double check all work.


How do you repair a blown head gasket on a 97 Chrysler Concorde?

Take it off, replace the gasket


How do you change the oil pan gasket on 1995 Chrysler 3.5v6?

The oil pan gasket on a 1995 Chrysler 3.5 V6 engine is changed by draining the oil and removing the retaining bolts. The pan is then lowered, the gasket removed, and a new gasket put in place.


Why would a 1996 sebring stall and rev up in idle?

intake gasket is leaking


How do you change the oil pan gasket on 1995 Chrysler 3.5 engine?

A person can change the oil pan gasket on a 1995 Chrysler 3.5 engine by first draining the oil. The pan is then unbolted, the original gasket removed, and a new one put in place.


When changing timing chain gasket on 350 Chevy do you have to change the pan gasket?

yes you have to change the pan gasket when doing the timing chain


Can you simply replace a head gasket on a 2.2 liter Chrysler motor or does it have to be totally rebuilt?

You can change a head gasket if that is all that is wrong.


Why does your 1997 Chrysler Town and Country leak antifreeze?

A part or gasket has failed.


Still have questions?