my hi/lo switch just crapped and the lights died completely before the switch quit for good. Maybe that's what happened to you? If anyone knows how to change the switch on a 1990 3.1L Corsica please post.
Thanks
Freaker
I had same problem on 89 Corsica. Hi/lo switch under dash and hard to take off unless you remove steering column so I unplugged switch and plugged in new switch and set new switch on low beam and wired switch to column. Now have low beams but since new switch not connected to activator rod (which goes to turn signal handle) as old switch still attached to activator rod, only have low beams. New switch about ten dollars. On 89 there is ground wire on body in front of battery. First, unbolt and clean ground, as bad ground can make lights inoperative so if you are lucky, cleaning ground could solve problem.
they had to use ropes
where is the trunk release button for 1993 chevy corsica
how to remove headrest of 95 chevy corsica without tabs
It is a TH125C(3T40) 3 speed.
Ask the same question at batauto.com in the forum for transmissions. Koug
A 1993 Chevy Corsica can only reach 111 MPH before the factory governor will be applied....this is with the 2.2 Liter engine
in the trunk
yes
NO
Bad bulbs Bad dimmer switch
there is no distributor. it uses coil packs and control modules
Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.