HeyJoe==They are not cleanable. If it is grinding between gears, the synchronizers need replacing. GoodluckJoe
I believe the fill plug is on the driver's side of the 5 speed manual transmission - on a level surface , clean the fill plug before removing and check to see if fluid level is level with the bottom of the opening . If it is not add the recommended transmission fluid until it is.
to clean: ranger for: pour you: toi, vous you need to conjugate ranger. to clean: ranger for: pour you: toi, vous you need to conjugate ranger. to clean: ranger for: pour you: toi, vous you need to conjugate ranger. to clean: ranger for: pour you: toi, vous you need to conjugate ranger.
Normally by starting the engine and putting in park while idling. Remove the transmission sip stick, wipe it clean, reinsert and remove and check the level. Make sure the engine and transmission is at operating temperature, and the car is sitting on a level surface. This is not true of ALL vehicles. Try looking in the owners manual for instructions, or it may be written on the dipstick. manual trans plug is on drivers side about halfway up, automatic has the dipstick on the pass side near firewall.
to clean or store something depends on how its being use "ranger ta chambre" "clean your room" "ranger les boites" "store the boxes"
According to my Chilton's repair manual : The 1991 to 1995 Ford Ranger / Ford Explorer vehicles use either type " F " automatic transmission fluid or Ford Premium Power Steering Fluid meeting Ford specification ESW-M2C33-F , ensure that the fluid added to the power steering pump is new and clean ---------------------------------------------------------------------------------------------------- If you use type " F " automatic transmission fluid , make sure it has an ( 8 ) digit Ford registration number beginning with " 2P " printed on the fluid container
To clean the inside headlight lens on a ford ranger just simply remove the cap and clean.
Clean it.
The engines in a 1993 Ford Ranger are fuel injected , so there is no carburetor
Ask a gunsmith for help
there's a fill plug on the front of the case. if your going to go through the work to add fluid, you should drain all of it and clean off the magnet on the end of the drain plug.
To change the clutch on a 1994 Ford Ranger with a 5-speed transmission, first, disconnect the battery and lift the vehicle securely. Remove the driveshaft, transmission crossmember, and the transmission itself after disconnecting the shifter and clutch hydraulics. Once the transmission is out, remove the old clutch assembly from the flywheel, clean the surface, and install the new clutch disc and pressure plate, ensuring proper alignment. Finally, reassemble by reversing the disassembly steps, and make sure to bleed the clutch hydraulic system before testing.
clean the throttle body on 20000 Ford Ranger 3.0 v6 is with throttle body cleaner purchased at an auto parts store.