Caliper pins.
You need a engine scanner, so you can scan the ABS system and see what is going on. Some auto parts stores will do this for free. Just call some and ask them if they can scan the ABS system for you.
there may be a recall for this - the polarity may be incorrect - call your dealer to see if this vehicle has an outstanding recall
the fuel injectors on a 1998 subran are located under the upper intake manifold this system is call the central sfi system
Did you use the correct bulb? Try reading your manual and see if you replaced with correct bulb. Call the dealer, I believe there is a recall on these brake lights.
Apply the parking brake,but not the driving brake, is the noise there? apply the brake,if the noise is only present when the brake is applied I would assume it is the anti-lock brake system. Get your VIN # of the vehicle and call a ford dealer and give them the # and ask if there are recalls for your vehicle. There are a few for this one but it depends on the vin. There is a anti-lock brake recall, but as I said it depends on where it was made if it falls under the recall.
it two bolts on the master cylinder that you take off and you have to plug the lines up upon removal. or you can call mr.autofix-it for mobile repairs! 678-933-2751 located in atlanta
Apparently, "brake jotter" is an old term from many decades ago which was used to refer to what we now call brake pulsation.
Call poison control.
Be smart and know for sure. Go or call the Chevy dealer parts dept in your area and ask for a transmission filter for your Prizm. They will ask you for your vehicles Vin Number from your registration card. The numbers from your registration will provide them with most if not all of your vehicles requirements including transmission information. If you want to do it yourself safely get under the car and count the amount of bolts on the transmission pan, it will be 15 or 18 bolts. Easier to call dealer. If you have a 3 speed transmission (Drive,2,L on your gear shift) you probably have a 15 bolt. If you have a 4 speed transmission you probably have 18 bolts. Hope this is helpful.
Likely it is a Disk brake. Unless you apply the brakes by peddling backwards, those are a form of drum brake.
On a multi-port injection system it's called the "fuel rail"
Brake Lathe.