This light indicates that you have an emissions contol problem, if the engine is not running poorly or if the vehicle is driving normally it may just be a sensor. Usually you will cause no further damage by driving your car. Inorder to properly diagnose your car you will need to have a technician read the code stored in the engine computer and diagnose it. ... you can try disconnecting the battery for one min. then reconnect the battery. (this in most cases will reset the computer) then drive tha car and see what happens... Good luck.
Its behind the radio/CD player. To service it, you must spend 3 hours taking everything apart to get to it.
The fuse box diagram for a 1986 Mitsubishi Montero is found through a factory service manual. The underneath cover of the fuse box also has each individual fuse labeled as per their function.
After repairing the cause of the code, you clear the code with a scan tool.
The computer has detected a malfunction and set a code. You need to have it checked with a scan tool.
Depends on how hard the vehicle has been worked, but Mitsubishi service manual says the Timing Belt should be changed at 100,000 miles.
call you local Mitsubishi dealer service dept. with the serial and model number and they will give it to you they might ask for the vin number in some cases to make sure the stereo is actually yours and not stolen
You can get the filters at www.freedrinkingwater.com Sears can service it.
Have dealer scan for trouble code, never jump another car with the engine running or the key in the on position, this has potential to be VERY expensive
Mitsubishi accessories can be purchased from a Mitsubishi Authorized Service Point, their locations are on the Mitsubishi website. They can also be bought from Canadian Tire and Tough Toys.
ask a qualified mitsubishi service man rather than ask.com
this can only be done at a mitsubishi dealers service department
You can find the 1993 Mitsubishi air conditioning service port on top of the air conditioning compressor. The air conditioning service port will be labeled as the low pressure port.