Rocker assembly 135ftlbs rocker box or housing is 35ftlbs
Remove a rocker cover and measure one.
Remove the valve cover. The rocker arm assembly can be removed by loosening the rocker arm screws. Each rocker arm will have a screw.
Subject: Sportster 1200 rear rocker coverQuestionI've replaced my front rocker cover gaskets due to an oil leak. Now I can't get the rear rocker cover off. I've removed the top bolts but the frame is blocking the removal of the cover. Is there an easy way to remove the covers?AnswerSorry I didnt answer you sooner. My hard drive decided to go south!The rocker cover will come off without removing the motor. Its a tight fit and you have to turn it to get it out, but it will come out. If you are removing the lower rocker cover you have to remove the pushrods to get it out.Good luck and happy ridingMike
in the rocker cover
They are under the rocker cover. You'll need to replace the rocker cover seal aswel if your replacing the glow plugs.
you have to cut out the fuel cells because they are partially attached to the rocker cover gasket but that will not completely remove it you also have to remove the radiator and then the rocker cover gasket will be suspended in the air. You then have to cut the cords and the gasket will fall to the ground. And the rest is pretty simple.
your problem is the rocker/engine cover is blocked the only way to fix the problem is to change the rocker/engine cover.
on the rocker cover
10mm
On the V6 the PVC valve is located on the drivers side rocker arm cover. Unsure about the I-4, but it should be on the rocker arm cover also.
You should be able to see a hose from the throttle body to the rocker cover. The hose may be big enough to completely cover the PCV valve so you might not be able to see it. Pull the hose out of the rubber grommet in the rocker cover. You should be able to see the PCV valve once you pull it from the rocker cover.