answersLogoWhite

0

  • Crankcases and PCV Valves
  • Oldsmobile Cutlass Supreme
  • Mazda 6

Where is the PCV valve located on a 1993 Oldsmobile Cutlass Supreme?


Top Answer
User Avatar
Wiki User
Answered 2006-07-21 19:40:30

You should be able to see a hose from the throttle body to the rocker cover. The hose may be big enough to completely cover the PCV valve so you might not be able to see it. Pull the hose out of the rubber grommet in the rocker cover. You should be able to see the PCV valve once you pull it from the rocker cover.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Where is the purge valve located on a 1996 Oldsmobile Cutlass Supreme?

wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine


Where is the pcv valve located on a 1991 Oldsmobile cutlass supreme?

its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.


Where is the modulator valve located on a 1992 Oldsmobile cutlass located?

In the transmission in front of the modulator


Why won't my rear disk brakes on a 1994 Oldsmobile Cutlass Supreme bleed?

Equalizer valve not allowing fluid flow to rear?


Where is the tps located in a 1993 Oldsmobile cutlass ciera?

Its located on the bottom of the throttle body right next to the fuel pressure valve.


Where are the pushrods located in a 1997 cutlass supreme?

Under the valve covers under the rocker arms


Pcv valve 1994 cutlass 3.4?

The positive crankcase ventilation valve (PCV) on a 1994 Oldsmobile Cutlass Supreme with the 3.4L is located on the left-front side (drivers) of the vehicle towards the firewall. The PCV will be located between two black hoses with appearing as a T-fitting. The OEM PCV is a AC Delco part# CV895C.


Where is the PCV valve on a 1994 Oldsmobile Cutlass Supreme 3.4 liter dohc v6?

it is locatated to at the right side rear of motor, next to the throttle body and the IAC valve, and tps sensor.


Valve adjustment on 1997 Oldsmobile cuttlass supreme?

ValVe adjustment on 1997 oldsmobile cuttlass 3.1


Where is the coils in 1995 cutlass supreme?

On a 96, coil packs (3) are located above rear valve cover, near firewall.


Are the push rods for the exhaust and intake on a 3.1 ltr Oldsmobile cutlass supreme the same length and which one is longer and which is shorter?

intake shorter but which is the intake or the exhaust valve which one is which


Where is low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6?

The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.


How do you locate and replace the PCV valve on a 1989 Oldsmobile Cutlass Ciera?

The PCV valve is located in the rocker cover (valve cover) Once you locate it pull up on the hose that is connected to it. Remove the PCV valve and put new one in. Reinstall in rocker cover.


Where is the pcv valve on an 84 Cutlass Supreme with a 3.8 liter engine?

It is behind the throtle body in the intake.


Where is the EGR valve located on an 89 Oldsmobile delta 88 and is it hard to change?

The 1989 Oldsmobile EGR valve is located on the top of the engine, near the back. It is quite simple to change.


Where is the PVC valve on a 3.8 engine?

where is the pvc valve located on a 1980 olds cutlass 3.8 v-6


Where is th EGR valve on a 1995 Oldsmobile Achieva 2.3l engine?

The EGR valve, on your 1995 Oldsmobile 2.3 liter engine, is located on the side of the air filter housing. The valve should be labeled as such.


Where is the transmission filter on a 1990 Oldsmobile Cutlass?

Inside the transmission attached to the valve body, under the trans pan, which must be removed to gain access.


Where is the EGR valve located on a 1999 Oldsmobile Alero with a 2.4L cylinder?

no egr valve on 1999 to 2001 2.4 alero


Where is the PCV valve located on a 1999 Oldsmobile Alero with a 2.4L you-4?

THERE IS NOT ONE.


Were is the egr valve located on a 1995 cutlass supreme?

On the 3100 engine it is located between the master brake booster and the rear head of the engine on driver's side. It has a wiring connector on top and EGR is held on by two 10mm bolts. Can be installed backwards if not careful.


How do you replace the head gasket located on a 1994 Oldsmobile Cutlass 3.4L?

To replace the head gasket on a 1994 Oldsmobile Cutlass 3.4L, everything on the top of the motor needs to be removed. The battery should be unhooked first, then the valve covers, then the head itself. Replace the new gasket after cleaning the old gunk off from the first gasket. It is a good idea to take a picture before, during, and after, to make sure everything is hooked up like it should be. One note, the valve cover gasket will also have to be replaced after removal.


Where is egr valve on 1993 cutlass ciera?

The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.


What is the valve clearance firing order on a '67 Oldsmobile Cutlass 330?

the same as a Chevrolet, 18436572, but olds and Pontiac distributers spin oposite. conterclock wise.


Where is IAC valve located on 92 olds achieva?

The 1992 Oldsmobile IAC valve can be found attached to the firewall in the engine compartment. The valve will be on the passenger side of the firewall.