Crankcases and PCV Valves
Chevy S-10
Oldsmobile Cutlass Supreme

Where is the PCV valve on a 1994 Oldsmobile Cutlass Supreme 3.4 liter dohc v6?

91011

Top Answer
User Avatar
Wiki User
2005-07-07 02:23:15
2005-07-07 02:23:15

it is locatated to at the right side rear of motor, next to the throttle body and the IAC valve, and tps sensor.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine

User Avatar

its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.

User Avatar

Equalizer valve not allowing fluid flow to rear?

User Avatar

ValVe adjustment on 1997 oldsmobile cuttlass 3.1

User Avatar

The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.

User Avatar

The positive crankcase ventilation valve (PCV) on a 1994 Oldsmobile Cutlass Supreme with the 3.4L is located on the left-front side (drivers) of the vehicle towards the firewall. The PCV will be located between two black hoses with appearing as a T-fitting. The OEM PCV is a AC Delco part# CV895C.

User Avatar

Under the valve covers under the rocker arms

User Avatar

The EGR valve, on your 1995 Oldsmobile 2.3 liter engine, is located on the side of the air filter housing. The valve should be labeled as such.

User Avatar

Its located on the bottom of the throttle body right next to the fuel pressure valve.

User Avatar

Inside the transmission attached to the valve body, under the trans pan, which must be removed to gain access.

User Avatar

On a 96, coil packs (3) are located above rear valve cover, near firewall.

User Avatar

You should be able to see a hose from the throttle body to the rocker cover. The hose may be big enough to completely cover the PCV valve so you might not be able to see it. Pull the hose out of the rubber grommet in the rocker cover. You should be able to see the PCV valve once you pull it from the rocker cover.

User Avatar

The PCV valve is located in the rocker cover (valve cover) Once you locate it pull up on the hose that is connected to it. Remove the PCV valve and put new one in. Reinstall in rocker cover.

User Avatar

The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.

User Avatar

the same as a Chevrolet, 18436572, but olds and Pontiac distributers spin oposite. conterclock wise.

User Avatar

Remove the vacuum hose from your 1989 Oldsmobile 3.8 liter engine PCV valve. Remove the retaining bolts from the valve. Reverse the process to install the new PCV valve.

User Avatar

The average 2.8, 3.1, and 3.4 (not dual overhead valve) holds 4.5 quarts of oil. These engines are all the same just different bores and strokes. They are 60 degree engines.

User Avatar

the map sensor is on a bracket between the firewall & the inside valve cover. it has a 3 wire plug on it & a vacuum hose that goes to it.

User Avatar

i own a 91 cutlass and did a head gasket a week later the exaust valve on number 5 cylinder was sticking so i had to have a valve job done on the heads..... this was my problem the only 2 things it can be is either yuors lifters that sit below ur lower intake or ur valves

User Avatar

Look under the air filter and mounted on the transmission facing the radiator is a gray and round metal valve with a vacuum line attached.

User Avatar

It's on the rear valve cover. The easiest way to change it is to pull off the alternator. It's also the easiest way to change the rear spark plugs and wires.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.