0
Ok, let's take a look at this; Here is what I found on your code, this is also the same as a whirlpool model. F06 means Drive motor tachometer
error Which means the control is unable to properly detect motor speed and the machine will shut down. If a failure occurs during high-speed spin the door will be unlocked after 3 minutes.
Here are some Potential Causes for this error Check wire harness connections between the Drive Motor/Tachometer and the Motor Control
Unit (MCU), and between the MCU and the Central Control Unit (CCU) Check the Drive Motor Check the MCU Check the Wire Harness
Replace failed component.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you reset fault codes on miele g858 dishwasher?
The waterproof error message means that there is water in the base of the dishwasher. The anti-flood float switch in the base went up and the machine is now inoperative.
What is the requirement temperature for commercial dishwasher?
140 f
What should the temperature be when on rinse cycle of dishwasher?
at aprox. 500 degrees f
P1506 on a 97 F-150 how to fix it?
Trouble code P1506 means: Idle Air Control Overspeed Error
What is error code P 0730 in ford f-450?
Trouble code P0730 means: Incorrect gear ratio
2006 Ford F-150 error code p0325?
Trouble code P0325 means: Knock Sensor 1 Circuit Malfunction
What was the purpose of the dishwasher?
So it would clean by themselves and save time
What does error 080040706 mean?
Error 080040706 means that you are trying to uninstall a program. However, the error code means that it can not be uninstalled.
What is a theoretical error?
A theoretical error is an error that is not quite proven, which means that it is also arguably not an error.
Getting f -- h error when trying to calibrate digiweigh dw- 100AS pocket scale?
how do you fix f--h error for digiweigh DW-350BS
What is error code f 48 on a 93 deville?
for error code answers try the cadillac forums
What does error code ER mean on a brada dishwasher?
The manual for Brada model ep9242aww says: Error Code E1 = longer inlet time. Possible Causes: Faucets not opened, or water intake is restricted, or water pressure is too low.
