To get your computers local network IP address, subnet mask, and default gateway typing ipconfig alone will display this information as shown below:
ipconfig
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . : hsd1.ut.comcast.net.
IP Address. . . . . . . . . . . . : 192.168.201.245
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.201.1
The command ipconfig is used to examine the current network connections. IP addresses, gateway addresses, and subnet masks can all be determined through ipconfig.
Ipconfig is used to show all current TCP/IP network configurations values and connections in Microsoft Windows. It is a command line tool.
It is where you can configure the settings of your internet access and restart your connection.
Ipconfig command is to know the IP address of your system.
ipconfig /release
ipconfig /renew if you're on windows
Ipconfig shows IP address, Subnet Mask, and Default gateway for all adapters. Ipconfig /all shows the description of each network connection along with additional information such as your physical (MAC) address, DHCP connections, Lease times, as well as in-depth IPv6 information.
Ipconfig and Ping both are commands of command line interface (CLI) .IPconfig is used to display all network configuration values . Ping is used to check whether a host can send or receive packets.
Open command prompt and simple write "ipconfig" and press enter. Note: Do not use colons "" Just use ipconfig
No, it will work on dynamic too.
ipconfig /release is the full command line.
assuming that by down you mean get... ipconfig if you want all ip settings then ipconfig /all command ipconfig If you mean to disable or turn off the ip to disconnect from the internet then ipconfig /release
IPConfig is an application in Microsoft. IPConfig displays all current network configuration values and can be used to modify a variety of network settings.
ipconfig/release and ipconfig/renew
ipconfig
ipconfig /renew is used to renew your DHCP IP address after releasing it with ipconfig /release. If no adaptor is specified, all adaptors are renewed.
ipconfig /all
Ipconfig is used to show all current TCP/IP network configurations values and connections in Microsoft Windows. It is a command line tool.
ipconfig /release
ipconfig /release
''ipconfig/all''