car will jerk forward and then go in reverse
does it shift into reverse and wont drive? if so its your tranny it needs to be replaced
pull the lever back to the "H" position. if it doesnt shift put your truck in reverse and pull back about a foot or so then put it back in drive and it should work. if all that fails it is broke. come to a complete stop, then put it in neutral and it should knock right out of low. If that doesnt work try reverse. answer if that doesnt work, unlock the front hubs then put in high, doesnt mean it is broke as first answer suggests
Generally shifting from reverse to drive, while still rolling, is possible but not recommended. This places a lot of stress on the transmission and other components of the drive train.
Park, reverse, neutral, Drive and low
Not sure of the question, but if your car is less than 7 yrs old, apply the brake first, then you can move the shift selector.
if you car doesnt have the brake sensor then yes if so then all you need to do is disconnect it. However I dont recomend this seeing as a kid could put it in drive or reverse with no trouble at all. This is why it was invented.
Sounds like a torque converter lock up solenoid.
Shift it on 2H, then "REVERSE" for about 10 to 15 Feet....
Shift linkage broken or misadjusted?
sounds like the auto transmission has a fault
my 2002 ford escape sensor is misfiring and it won't shift into drive
Mis adjusted shift linkage, internal failure
You have to take it to a shop because you cant get to it and you need certain tools.
shift to nutral,then move lever to reverse
I am the owner of a 94 cutlass and it will not shift in reverse ,it will however shift into drive if i rock the car....can you tell me whats wrong or how to fix it please..my email is firstname.lastname@example.org
i have a 92 s-10 blazer and it has no reverse Andy ideas?. it will go in to drive and shift in to all the gears..but will no go into reverse? can u help me
Check the fluid level. If the fluid level is OK, put the van in reverse on a parking lot and drive it around in reverse. Then try it to see if it will shift into 2nd. If it does shift then, it may be just a clogged filter. If it still will not shift into 2nd you may have to take it over to Cottman and have them check it out.
check the transaxle range switch and positioning....the holes should line up in neutral
Check to make that the brake lights are working - shift interlock is in the same circuit - could ba a bad fuse. You can try turning the key (with engine off) o to the first position (Unlock) shift to neutral to start vehicle and then shift to "Drive or Reverse"
If your Mercedes won't shift out of park, you might have an issue with the brake sensor or the brake itself. The brake must be fully depressed in order to shift from park to drive or reverse.
I am having the same problem on my 94. It will go into drive but that is it.
How can you change the light bulb for the gear shift on a 2002 Toyota Camry?
Simply start the vehicle with the shift lever in the Park position. If you wish to go backward place the shift lever in the R location. When you're ready to move forward place the shift lifter in the D position. Only shift from park to reverse or to drive when the vehicle is sitting still.