Want this question answered?
wheel bearings are going bad, need to change your hub assembly
It might mean that he wants you to ask him out.
It's under the front right headlight, need to remove headlight assembly and cut hole to get to relay, which is under the plastic frame that holds headlight assembly. The other option is to remove the front bumper assembly to access. If the relay repeatedly fails the fan motor will need replaced.
i need to replace a throttle sensor and put a throttle body rebuild kit in
Well its a wheel bearing hub assembly that you need to buy. Autozone has a Timken/Wheel Bearning/Hub Assembly-front its $79.99 and they have the Duralast/Wheel Bearing/Hub Assembly-Front $51.99
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
The front wheel bearings must be pressed into and out of the spindle/hub assembly. You will need to take the spindle assembly to an automotive machine shop to have this done.
need diagram of 1992 4wheel drive front hub disasembly
You need to replace the front axle Every 80,000 to 120,000 They wear out, normal maintance
you must remove the front grill assembly, then you should be able to do it, just need a screw driver
you need to press out the bearing inside the hub assembly.
i need to see 1998 front assembely lexus g300